User manual HOOVER H130E

[. . . ] Do not lean on the door when loading the machine or use the door to lift or move the machine. WARNING Do not use the product if the fluff filter is not in position or is damaged; fluff could be ignited. WARNING Where the hot surface symbol is located the temperature rise during operation of the tumble dryer may be in excess of 60 degrees C. Lint and fluff must not be allowed to collect on the floor around the outside of the machine. [. . . ] The plug should be accessible for disconnection after the appliance has been installed. The wires in the mains lead are coloured in accordance with the following codes: Blue Brown Green and Yellow NEUTRAL LIVE EARTH Do not plug the machine in and switch it on at the mains until the installation is completed. You may be charged for a service call if a problem with your machine is caused by incorrect installation. CE Appliance complies with European Directive 89/336/EEC, 73/23/EEC and subsequent amendments. Adjusting the feet Once the machine is in place the feet should be adjusted to ensure that the machine is level. Adjust the four feet to ensure the machine is firm and level. If the mains cord on this appliance is damaged, it must be replaced by a special cord which is ONLY obtainable from the Hoover spares service. It must be installed by a competent person. Call 01204 556111 7 40002267. qxd 26/11/2004 12:34 Page 8 Ventilation For your safety, this dryer must be correctly installed. If there is any doubt about installation, call the national GIAS Service number for advice. Adequate ventilation must be provided in the room where the tumble dryer is located to prevent gases from appliances burning other fuels, including open fires, being drawn into the room during operation of the tumble dryer. Exhaust air must not be discharged into a flue which is used for exhausting fumes from appliances burning gas or other fuels. Check regularly that the air flowing through the dryer is not restricted. To ensure adequate ventilation the space between the bottom of the machine and the floor must not be obstructed. There should be a gap of at least 12mm between the machine and any obstructions. Prevent items from falling or collecting behind the dryer as these may obstruct the air inlet and outlet. NEVER install the dryer up against curtains. 08705 400 600 (Eire 018301 666) AIR INLET VENTS AIR OUTLETS AIR OUTLETS IN THE BASE 8 40002267. qxd 26/11/2004 12:34 Page 9 Preparing the load Before using the tumble dryer for the first time: Please read this instruction book thoroughly. Garments may also become stiffened when dried outside on a washing line or inside on radiators. The Fast Iron process relaxes the creases in the fabric making ironing quicker and easier. Gently close the door pushing it slowly until you hear the door `click' shut. The load is dried by tumbling in thermostatically controlled warm air. Cool air is used for the last 15 minutes to reduce creasing and cool the load ready for handling. When the program is fully completed the drum will stop rotating and the dial will point to 0. Clean the filter and empty the water container after every drying cycle to ensure maximum dryer efficiency. Clean the condenser after approximately every 10 drying cycles to ensure maximum dryer efficiency. WARNING!The drum, door and load may be very hot. 15 40002267. qxd 26/11/2004 12:36 Page 16 Cleaning and Routine Maintenance IMPORTANT Always switch off and remove the plug from the electricity supply before cleaning this appliance. Cleaning the dryer Clean the filter and empty the water container after every drying cycle. After each period of use, wipe the inside of the drum and leave the door open for a while to allow circulation of air to dry it. To prevent the door sticking or the build up of fluff periodically clean the inner door and gasket with a damp cloth. For electrical data refer to the rating label on the front of the dryer cabinet (with the door open). Technical specifications Drum capacity Maximum load Height Width Depth Energy Label Band 115 litres 6 kg 85cm 60cm 60cm C 16 40002267. qxd 26/11/2004 12:38 Page 17 Troubleshooting What might be the cause of. . . Defects you can remedy yourself Before calling GIAS Service for technical advice please run through the following checklist. [. . . ] You should retain the receipt issued by the retailer when you purchased the machine to show to the call out engineer, should you need to consult one. If your appliance shows signs of a defect or is not working properly, before you contact GIAS Service we recommend you carry out the checks detailed within the Troubleshooting section. If the problem with the appliance persists after completing all the recommended checks, please dial the GIAS Service number. It is important you tell the GIAS advisor your product's model number and serial number, which you will find on the rating label (16 characters, beginning with the number 3), found on the front of the appliance (door area). [. . . ]