User manual HOOVER FLOORMATE SPINCRUB FH40010

[. . . ] Make sure all parts are located before disposing of packing materials. 2 Rotate bottom handle support (A) up to the upright position until a snap is felt. 3 Align control rod (B) on upper handle (C) with slot in bottom handle support (D). Push upper handle (C) all the way down until you hear it snap in place. [. . . ] Remove loose debris from filter by tapping the filter or gently brushing using your hand. Dry or loose debris will also collect on the filter screen located in the tank lid. 19 To remove debris from screen, remove the pleated filter from the lid. The filter screen may also be cleaned by rinsing it under running water. Replace lid onto Dirty Water Tank, pressing down firmly until snapped in place. 20 To replace Dirty Water Tank, place bottom of tank behind ledge (D) and push tank straight into cleaner body until it is locked in place. In this position, the brushes will not rotate and are raised off the floor surface. To wet clean with brushes turned ON, turn the dial to the WASH position. If using cleaner on sealed wood floors, inspect floor surface for worn finish, bare wood or separated joints. Do not use FloorMateTM SpinScrub® cleaner to wet clean sealed wood floors if any of these conditions exist. Fill Clean Water Solution Tank with either Floor to Floor Cleaning Concentrate or Grout Cleaner, depending upon the type of floor being cleaned, and water (see Figs. The cleaner's suction will pick up the dirty solution throughout cleaning. To greatly enhance drying of the floor surface, release trigger and turn Mode selector dial to the DRY position. To continue cleaning another area, turn Mode selector dial to WASH position. Empty Dirty Water Tank or clean the filter when the motor sound becomes higher in pitch and there is a loss of suction (see "Automatic shut-off" section). Your HOOVER® FloorMateTM SpinScrub® cleaner may be used to clean wood floors that have been sealed with a polyurethane coating and can be cleaned with water. When cleaning sealed wood floors, make sure all areas are completely dry. When switching between wet cleaning and wet pickup, it is not necessary to turn the cleaner off. To prevent damage to wood floors, follow the flooring manufacturer's cleaning recommendations. Your cleaner may also be used to pick up small liquid spills (1 quart or less, never to exceed 1/4 inch in depth) on non-carpeted floors. Do not use the cleaner to pick up flammable or combustible liquids or chemicals. Do not use the cleaner to pick up detergents that contain solvent based ingredients. [. . . ] Always identify your vacuum by the complete model number when requesting information or ordering parts. WARNING: To reduce the risk of fire and electric shock due to internal component damage, use only Hoover® cleaning products and Hoover® hard surface attachments intended for use with the appliance as noted below. When cleaning a hard surface, the Hoover® hard surface attachment below must be used (optional if not included): 5 Brush/Dual Brush Hoover® part # 48417008. When cleaning a hard surface, the optional Hoover® hard surface attachment below must be used: 6 Brush Hoover® part # 36419008 5 Brush Hoover® part # 48417007. [. . . ]