User manual HOOVER FLOORMATE

[. . . ] If an extension cord is absolutely necessary, use at least a 16 gauge 3-wire cord which has a 3-prong grounding type plug and a 3-pole receptacle that accepts the machine plug. ⷠKeep detergents and other cleaners out of children's reach. ⷠDo not pick up chlorine bleach, drain cleaner, gasoline or any other toxic material with this appliance. ⷠWhen using recommended chemicals with this machine, be certain area is well ventilated. [. . . ] Your HOOVER FloorMateTM SpinScrubTM 800 Cleaner can be used to both vacuum dry debris and wet clean non-carpeted floor surfaces such as vinyl, tile, marble and sealed wood. CAUTION: To prevent damage to wood floors, follow the flooring manufacturer's cleaning recommendations. If using cleaner on sealed wood floors, inspect floor surface for worn finish, bare wood or separated joints. Do not use FloorMateTM SpinScrubTM Cleaner to wet clean sealed wood floors if any of these conditions exist. In this position, the brushes will not rotate and are raised off the floor surface. To wet clean with brushes turned ON, turn the dial to the WASH position. The solution tank holds detergent and water that is to be dispersed onto the surface being cleaned. How to fill 21 A To remove tank, squeeze release button and pull tank 20 straight out. For hard surface floors such as vinyl, linoleum, laminate wood, polyurethane sealed wood or other wood floors that can normally be cleaned using water, use one cap (2 oz. Check for worn spots or joint separations before using, as these conditions could lead to damaged flooring when using water to clean floor. When cleaning ceramic and other tiles, use the set of grout brushes with gray bristles included with your FloorMateTM SpinScrubTM 800 Cleaner. Use these for tile floors where extra attention is needed for cleaning grout. CAUTION: HOOVER® Floor to FloorTM Cleaning Concentrate and HOOVER® Grout Cleaner cannot be used in Hoover SteamVacTM products. If rubber ring (D) on cap has become dislodged, reposi24 tion it with uneven side against ledge (E) as shown. Cap must be locked in place for proper performance and to prevent leaking. Automatic shut-off An automatic suction shut-off is built into the recovery tank to prevent the tank from overflowing. When the shut-off activates, the cleaner will not pick up debris and the sound of the motor will change. How to empty 27 B Turn cleaner off and disconnect from electrical outlet. Although not necessary for satisfactory performance, it is recommended that the recovery tank be emptied after dry vacuuming and before wet operation. To remove tank, press down on release button (B) 27 and pull tank straight out. Remove loose debris from filter by tapping the filter or gently brushing using your hand. Dry or loose debris will also collect on the filter screen located in the tank lid. [. . . ] This warranty provides, at no cost to you, all labor and parts to place this appliance in correct operating condition during the warranted period. This warranty applies when the appliance is purchased in the United States including its territories and possessions, or in Canada or from a U. Appliances purchased elsewhere are covered by a limited one year warranty which covers the cost of parts only. This warranty does not apply if the appliance is used in a commercial or rental application. [. . . ]