User manual HOOVER FL700 FLOORMATE

[. . . ] Keep hair, loose clothing, fingers, feet and all parts of body away from openings and moving parts. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes. Do not pick up or use flammable or combustible materials such as gasoline or fine wood sandings or use in areas where they may be present. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow. [. . . ] Remove cardboard packing insert from squeegee area on underside of nozzle. [4] While holding nozzle in place, slide latches inward to lock in place. [5] Cleaning Floors Recommended cleaning sequence: VACUUM: Vacuum to remove loose dirt, hair and debris. [1D] Fill Clean Water Solution Tank with either floor cleaning detergent and water. The cleaner’s suction will pick up the dirty solution throughout cleaning. To greatly enhance drying of the floor surface, release trigger and turn Mode selector dial to the DRY position. [1D] Continue to move cleaner over the area to pick up the dirty solution. To continue cleaning another area, turn Mode selector dial to WASH position. Empty Dirty Water Tank or clean the filter when the motor sound becomes higher in pitch and there is a loss of suction (see “Automatic shut-off” section). cleaning the Filters The tank lid contains a washable , reusable filter. Remove loose debris from filter by tapping the filter or gently brushing using your hand. Dry or loose debris will also collect on the filter screen located in the tank lid. The filter screen may also be cleaned by rinsing it under running water. Replace lid onto Dirty Water Tank, pressing down firmly until snapped in place. To replace Dirty Water Tank, place bottom of tank behind ledge (d) and push tank straight into cleaner body until it is locked in place. Picking up spills Your cleaner may also be used to pick up small liquid spills (1L or less, never to exceed 1/4 inch in depth) on non-carpeted floors. To move your cleaner from room to room, put handle in upright position, tilt cleaner back on rear wheels and push forward. The cleaner may also be lifted using the carrying handle (A) on the front of the cleaner. Do not store cleaner on a wood surface unless cleaner is completely dry. Cleaner should be in the upright position for easier assembly of the nozzle. [. . . ] spares Washable Filter Brush Block Low suction Washable filter is dirty. S116 35601336 F5 35601337 Hoover Service Should any faults occur with your cleaner during the first 12 months contact the Hoover Customer Helpline on the number below. Quality Hoover’s factories have been independently assessed for quality. Our products are made using a quality system which meets the requirements of ISO 9001. [. . . ]