User manual HOOVER AWMPD4 47LH6/1-S

[. . . ] We are proud to always offer new, innovative and technologically advanced products, with a complete range of home appliances to ensure true assistance in your daily routine. Carefully read this manual for correct and safe appliance use and for helpful tips on efficient maintenance. Only use the washing machine after carefully reading these instructions. We recommend you always keep this manual on hand and in good condition for any future owners. [. . . ] L By this option you can reduce the maximum spin speed for the set programme, until it is completely excluded. L If the label does not show any instructions, you can spin to the maximum speed set for the programme. To prevent damage to the fabrics, it is not possible to increase the speed over the maximum one set for each programme. L It is possible to modify the spin speed at any time, without shifting the machine to PAUSE. If the appliance detects the presence of excessive foam, it may exclude the spinning phase or extend the duration of the programme and increase water consumption. The machine is fitted with a special electronic device, which prevents the spin cycle should the load be unbalanced. This reduces the vibration, improves noise reduction and prolongs the life of the washing machine. dELAY START button L This button allows you to pre-programme the wash cycle to delay the start of the cycle for up to 24 hours. L It is possible to cancel the delay start by pressing the ON/OFF button (for at least 3 seconds). sTEAM button L This button allows a specific treatment to follow certain wash cycles (please refer to the program table). L The steam function works by relaxing creases in wet garments and as a result reduces the time needed to iron these items. L Every program provides a dedicated steam treatment in order to ensure the max imum cleaning efficiency according to the items fabric type and colour. L To delay the start use the following This button allows you to choose - Press the button once to activate it (0:00h appears on the display) and then press it again to set a 30 minutes delay (0:30h appears on the display). The pre-set delay increases by 30 minutes each time the button is pressed, until h24 appears on the display, at which point pressing the button again will reset the delay start to zero. - Confirm by pressing the START/PAUSE button (the light on the display starts to flash). The countdown will begin and when it has finished the programme will start automatically. L This option allows you to make a prewash and it is particularly useful for heavily soiled loads (can be used only on some programmes as shown in the table of programmes). If the detergent Autodose system is off, to make a prewash, you need to pour the powder detergent directly into the drum. In this case, it is suggested to use only the 20% of the quantity reported on the detergent package. L This option (available only in some programmes) allows you to wash the load in a much larger quantity of water and this, together with the new combined action of the drum rotation cycles, where water is filled and emptied, will give you garments which have been cleaned and rinsed to perfection so that the detergent dissolves completely, ensuring an efficient cleaning action. SOME MODELS are provided with the automatic dosage, that carries out a precise dosage of detergent and softener, up to 20 washing cycles*, providing a perfect cleaning of your garments. This way water and energy wastes are reduced, as the right detergent and softener quantities are perfectly to the milligram dosed, according to the type of garment, to the weight of the clothes and to the water hardness. [. . . ] If this is experienced remove the load de-tangle it, reload it and restart the spin program. This could be due to the fact that water has not been completely drained: wait a few minutes. Some models include a "no spin" function: make sure it is not selected. Excessive detergent can impede the spin cycle, ensure the correct amount of detergent is being used. [. . . ]