User manual HOOVER AC110

[. . . ] You will need to wait a little bit steam is ready before restarting ironing. In order to facilitate the carrying and the storage of your ironing system, your appliance is designed with a lock system (2). Please follow the underneath indications in order to lock correctly your iron on the resting mat (3). Your steam generator is equipped with an ergonomic carry handle (4) that will allow you to comfortably transport your appliance when required. [. . . ] professional Iron Models: Connect the appliance with the main cord to the earthed socket. Press the iron on/ turned up and inform you that the appliance is running on. Select the temperature of the soleplate by turning the dial (12) on the iron to the will indicate you that the soleplate has reached the requested temperature. Help: To know the best suitable temperature for each textile, check the laundry care label of the article to be ironed. Please note that during use, the temperature light goes on from If you select a lower temperature while ironing, wait until the iron has cooled down to the set temperature before you continue ironing. If the temperature is too low, some drops of water could escape from the soleplate. Please raise up the temperature abov to avoid this issue Dry Ironing Domestic Iron Models: Select the temperature of the soleplate following the indications of chapter 3. Start your ironing without pressing the steam trigger (13), when the soleplate reaches the appropriate temperature. Start your ironing when the soleplate reaches the appropriate temperature. On the stand, when the steam will be ready to be used, the dedicated lamp (1d) will Steam lock function: The steam lock allows you to steam iron without pressing the steam trigger. To activate or deactivate the steam lock, slide forwards or backwards the steam lock (13). Next time you will plug and switch on your appliance, the rinse light (1e) will start your ironing session immediately. Models Without "Rinse" Light Before proceeding, be sure that the appliance is cooled down and unplugged for at least 2 hours. Unscrew the boiler rinse safety cap anti-clockwise with a coin and remove it. Fill the boiler with 0, 2 litres of tap water using a bottle and a in the sink. Screw the boiler rinse safety cap with a coin and put back the calc removal cap (17). In any case, do not use any descaling products to clean or rinse the boiler. Wait at least 30 minutes allowing the soleplate and the generator to cool down. For model SRD 41110, put the anti-wrinkles brush on its support and put the cable in its storage. Use the handle (4) in order to carry the appliance by following the requested instructions of chapter 1. Then you can take away your appliance in order to store it safely and easily. There is a connection problem The appliance is not switched on The soleplate temperature is too low Check the mains cord, the plug and the wall socket Press on the on/o switch Set a higher temperature of the soleplate Press on the on/o switch Wait a few moments until the steam ready LED is o Re ll the water tank Press the steam trigger It works but steam is not visible as very hot and dry Switch o the appliance and let it cool down. [. . . ] "Istituto del Marchio di Qualità" (IMQ) ), the independent italian national authority for the safety of domestic electrical appliances, ensures that European safety standards are met and maintained throughout the production life of an appliance. All appliances that pass the requirements are permitted to carry the IMQ mark of safety. quality ISO 9001 Hoover's factories have been independently assessed for quality. Our products are made using a quality system which meets the requirements of ISO 9001 The Environment This appliance is marked according to the European Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). [. . . ]