User manual HOOVER AB130

[. . . ] To ensure safety when disposing of an old washing machine disconnect the mains plug from the socket, cut the mains power cable and destroy this together with the plug. To prevent children shutting themselves in the machine break the door hinges or the door lock. If the appliance is not running properly or breaks down, switch it off, disconnect the plug from the socket, turn off the water supply and do not tamper with the appliance. Do not lean on the door when loading the machine or use the door to lift or move the machine. [. . . ] The second, called Relative Time Mode (RELATIEF), allows you to delay the start or end of your wash cycle by adding hours to the current time displayed on the clock, e. You can select which option you require by pressing the button until your preferred option is displayed, and then pressing the button to accept the option you have chosen. If you wish to change any of the menu settings at a later date, you can enter the menu as 19 Previously described, run through the menu options from the beginning and change whichever options you wish. This may be useful for changing Set New Time when Daylight Saving starts or ends. Once set, the menu options will remain in the memory of the machine even if the machine is unplugged or there is a power cut. The programme selector must be returned to the OFF position to reset the controls between each wash cycle. Turn the machine on by selecting a programme using the programme selector. The display will then indicate the name of the programme, the spin speed and temperature of the wash and this display will remain until you press the button or return the programme selector to the OFF position. After selecting the programme and the required options (see the Wash Options section of this manual), press the button once to start the wash cycle. The display will indicate that the door is locked and the machine will begin to sense the wash load and ask you to wait. After the appropriate parameters have been programmed by the machine the display will indicate the approximate time until the end of the programme. Programme Synthetics ( 50) Fast Iron function The programme is completed by a short spin, of very low speed. The machine stops in the final rinse stage and the option indicators blink. The load is held in the water in the drum, thus reducing creasing and enabling easier ironing. The machine stops in the final rinse stage and the option indicators blink. The load is held in the water in the drum, thus reducing creasing and enabling easier ironing. The machine stops in the final rinse stage and the option indicators blink. The load is held in the water in the drum, thus reducing creasing and enabling easier ironing. Action required to complete the cycle To select a full spin cycle please turn the dial to the required spin programme (see Programme Guide). The machine will then pump out the water and the programme will conclude with a short spin. Finally, the programme carries out a brief tumbling action to loosen the items in the load. Press the button and the machine will pump out the water and complete the cycle with a short spin. [. . . ] If the problem persists after completing the recommended checks, please call GIAS Service, they may be able to assist you over the telephone. If the DOOR LOCKED (DEUR OP SLOT) message is displayed and the machine does not start this means that the machine cannot fill with water, check the following: 1. Ensure that there is not a blockage in the drain hose or the hose is not kinked. If connected to the sink waste make sure you have cut the membrane or removed the bung from the under sink drainage unit. [. . . ]