User manual HOOVER 1300 SPECIAL EDITION CA232

[. . . ] Consult GIAS Service for possible repair. Call 08444 995599 Unpacking the Product 1. Remove the polythene sleeve and lift the dryer off the polystyrene base. Check that no damage has occurred to the machine during transit. If it has, call for service by GIAS. Call 08444 995599 Dispose of the packaging safely. Make sure it is out of the reach of children, it is a potential source of danger. Failure to comply with the above can compromise the safety of the appliance. [. . . ] Check regularly that the air flowing through the dryer is not restricted. To ensure adequate ventilation the space between the bottom of the machine and the floor must not be obstructed. There should be a gap of at least 12mm between the machine and any obstructions. Prevent items from falling or collecting behind the dryer as these may obstruct the air inlet and outlet. NEVER install the dryer up against curtains. For your safety, this dryer must be correctly installed. If there is any doubt about installation, call the national GIAS Service number for advice. 08444 995599 (Eire 0818 2000021) AIR INLET VENTS AIR OUTLETS AIR OUTLETS IN THE BASE 7 40006170. qxd 30/09/2009 16:37 Page 8 Preparing the load Before using the tumble dryer for the first time: Please read this instruction book thoroughly. Wipe the inside of the drum and door with a damp cloth to remove any dust which may have settled in transit. Clothes preparation Make sure that the laundry you are going to dry is suitable for drying in a tumble dryer, as shown by the care symbols on each item. Do not overload the drum, large items when wet can exceed the maximum admissible clothes load (for example: sleeping bags, duvets). Check that all fastenings are closed and that pockets are empty. Place clothes loosely in the drum to make sure that they don't get tangled. Maximum drying weight Cottons Max. 4 kg 8 40006170. qxd 30/09/2009 16:37 Page 9 Sort the load as follows: By care symbols These can be found on the collar or inside seam: Suitable for tumble drying. If the item does not have a care label it must be assumed that it is not suitable for tumble drying. By amount and thickness Whenever the load is bigger than the dryer capacity, separate clothes according to thickness (e. g. Gently pull the bottom of the kickplate so that it unclips from the dryer. The top section can then be unhinged allowing the kickplate to be completely removed. 2. Pull firmly on the handgrip and slide the water container out of the dryer. Support the container with both hands. 4. Open the lid located on the top of the container and empty the water. Refit the kickplate by engaging the hinges at the top and 'snapping' the lower clips into place. 5. 15 40006170. qxd 30/09/2009 16:37 Page 16 Condenser Important: Always switch off and remove the plug from the electricity supply before cleaning the condenser. To maintain the efficiency of the dryer regularly check that the condenser is clean. To remove the condenser 1. Turn the two locking levers anti-clockwise and pull out the condenser. Pull out the condenser unit. 4. Gently remove any dust or fluff with a cloth, then wash the unit by holding it under a running tap turning it so that water flows between the plates, to remove any dust or fluff. Refit the condenser ensuring it is in the correct way (as indicated by the arrow) and pushed firmly into place. Refit the kickplate. 5. 6. 16 40006170. qxd 30/09/2009 16:37 Page 17 Operation 1. Gently close the door pushing it slowly until you hear the door 'click' shut. Turn the Programme Selector dial to select the required drying programme (see Programme Guide). [. . . ] To commence the programme press Start/Pause and the appliance will complete the drying cycle at the end of this time. The 3, 6 or 9 hour indicator light will flash to indicate that the start delay is in progress. Cleaning and Routine Maintenance IMPORTANT Always switch off and remove the plug from the electricity supply before cleaning this appliance. Cleaning the dryer Clean the filter and empty the water container after every drying cycle. After each period of use, wipe the inside of the drum and leave the door open for a while to allow circulation of air to dry it. To prevent the door sticking or the build up of fluff periodically clean the inner door and gasket with a damp cloth. For electrical data refer to the rating label on the front of the dryer cabinet (with the door open). Technical specifications Drum capacity Maximum load Height Width Depth Energy Label Band 115 litres 8 kg 85cm 60cm 60cm C 18 40006170. qxd 30/09/2009 16:37 Page 19 Troubleshooting What might be the cause of. . . Defects you can remedy yourself Before calling GIAS Service for technical advice please run through the following checklist. [. . . ]