User manual HONEYWELL TS 131

[. . . ] According to its intended use · in good condition · With due regard to safety and risk of danger. [. . . ] Bonnet Valve piston with seal disc Spring Remote double temperature sensor with capillary tube · immersion pocket G 1/2" (ISO 228) 6. Options TS131-3/4A Opening temperature 95 °C capillary tube with protection sheath 1300 mm, with approved construction TS131-3/4B Opening temperature 95 °C capillary tube with protection sheath 4000 mm TS131-3/4Z Special Versions available on request 7. The valve and the sensor must be installed carefully to avoid any damage to the capillary tube · The opening on the blow-out line must be clear and easy to monitor · Ensure no persons are in danger when blowing off the valve MU1H-1543GE23 R0709 8 A sufficiently dimensioned discharge line must be provided kvs-values p = 1 bar 3 m3/h with 2 intact sensor systems 2. Installation of the thermal discharge safety valve does not replace the diaphragm relief value in the cold water supply line to the water heater. Install a thermal discharge safety valve into the hot water line according to the installation diagram - Flow direction is marked by an arrow 2. Push the heat sensor into the immersion pipe up to the stop point and secure with a round screw to stop it being pulled out 7. [. . . ] TS131KF Piston guide complete for TS131 Connection size 3/4" TS131TWG-3/4 Temperature motion transducer for TS131 Opening temperature 95°C Option A = Capillary tube with protection sheath 1300 mm Option B = Capillary tube with protection sheath 4000 mm Installation diagram min. [. . . ]