User manual HONEYWELL T7350

[. . . ] Registered Trademark Copyright © 2003 Honeywell International Inc. All Rights Reserved 63-2604 FEATURES · Typically used in buildings (including: restaurants, shopping malls, office buildings and banks) under 55, 000 square feet. [. . . ] NOTE: This is further modified by selection of conventional or electric heat. 4 63-2604 PROGRAMMING The thermostat operates at the Occupied temperature setting unless the thermostat is programmed. The thermostat can be set for two Occupied and two Not Occupied times for each day of the week (28 independent time settings). The Temporary Occupied key provides quick setpoint changes for increased comfort during Not Occupied periods. The Temporary Not Occupied key provides energy efficient operation for extended periods of time. IMPORTANT Programming the thermostat with the keypad requires 24 Vac (turn on system power). NOTE: Before starting programming, use Table 2 to organize the program schedule. Setting Current Day/Time This can be done using the keypad. IMPORTANT Once you set the day/time once, you should not need to set it again. As a result, if you use a PDA to set the day based upon the calendar (MM/DD/ YYYY), the device will not allow the keypad to change the day. 5 63-2604 Table 2. Day Monday Tuesday Wednesday Thursday Friday Saturday Sunday NOTE: 12:00 PM is Noon, and 12:00 AM is Midnight. 6 63-2604 Occupied Period 1 Not Occupied Period 1 Occupied Period 2 Not Occupied Period 2 Temperature Occupied HEAT COOL Set Day/Time Day Time Override Temporary Temporary Occupied Not Occupied Not Occupied HEAT COOL Day Clear Occupied Not Occupied Start Time Schedule System Copy HEAT COOL Fan ON AUTO Run Schedule M19610BB Fig. NOTE: Sun = Sunday, Mon = Monday, Tue = Tuesday, Wed = Wednesday, Thu = Thursday, Fri = Friday, Sat = Saturday. 4. 7 Press Run Schedule. 63-2604 Setting Schedule Times Use the keys in the "Schedule" area of the keypad for this procedure. Repeat steps 2 through 5 until finished. NOTE: The thermostat must be in program mode to use the copy feature. NOTE: DONE displays for two seconds then the program display reappears. 8. 8 Copying a Day Use the keys in the "Schedule" area of the keypad for this procedure. Repeat steps 2 through 6 for all the days desired. Press Occupied or Not Occupied until the start period to be cleared is displayed. [. . . ] Press to display the default setpoint. Changing Temperature Setpoint Until Next Program Period 1. The temporary temperature appears for approximately ten seconds, then the room temperature is displayed. NOTE: The only way to change this setpoint is to change the Not Occupied setpoint. Automation and Control Solutions Honeywell International Inc. [. . . ]