User manual HONEYWELL MN12CES

[. . . ] Important: Before installing the unit, place it UPRIGHT for 1 hour before use to allow the refrigerant to stabilize. Manually adjust the air vent located at the top of the unit to adjust the direction of air flow. READ AND SAVE THESE INSTRUCTIONS Improper handling can cause serious damage to the appliance. If the power cord is damaged, it must be replaced by the manufacturer or an authorized service agent. [. . . ] If room temperature is higher than 25°C (77°F) fan speed can be adjusted; otherwise fan speed is preset to LOW. Note: If the unit will be used mainly as a dehumidifier, do not connect the exhaust hose and let the warm air return in the room. Continuous drainage is then necessary and more efficient (refer to Continuous Draining). TIMER CONTROL While the unit is turned on, press the timer button then press the À or · To select the number of hours you would like the unit to continue to run. AUTO TURN OFF: While unit is running, press the press the À or · Button to select the number of hours you want the unit to run in air conditioning mode. AUTO TURN ON: When unit is in a standby mode (plugged in with power light on), then press the À or · Button to select the number of hours until you want the unit to automatically start running. tEMPERATURE / TIMER SET CONTROLS · Used for adjusting the timer and thermostat. Button is pressed, the set temperature is displayed and may be adjusted. note: By pressing both À/ · Set buttons at the same time, the display will toggle between Celsius and Fahrenheit. If the internal tank becomes full, the Power Control light will flash and the unit will not operate until the unit has been drained (refer Water Condensation Drainage). After switching the air conditioner off, you must wait 3 minutes before switching it back on again. REMOTE CONTROL The functions work the same as the portable air conditioner's Touch Screen Control Panel. Timer Control In running mode: Auto switch off In stand-by mode: Auto switch on Press À or · Button to adjust the time setting for 1 hour intervals. Key is pressed in cool mode, the set temperature is displayed and may be adjusted. Timer setting is available from 1-24 hours by pressing the key À or · Press this button to change the operation mode in the order of: *Applicable for models with Heating feature only. Battery Installation: Remove the cover on the back of the remote control and insert two AAA batteries with + and - pointing in the proper direction according to the polarity markings. Remove the batteries if the remote control is not in use for a month or longer. All batteries should be replaced at the same time, do not mix with old batteries. Operation is subject to following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] PROBLEM The air conditioning unit does not start Runs a short while only Runs but not cooling Batteries in the remote control need The power cord is not properly The thermostat temperature setting is too close to room temperature. Reset the safety LCDI plug, if problem persists contact our customer support (USA / Canada / Mexico only). Heater is not switching ON (This may only be applicable for Portable Air Conditioner models with built-in Heating function only). Heating is activated only when the ambient temperature is below 25°C (77°F). [. . . ]