User manual HISENSE RB338N4AG2

[. . . ] Safety and warning information_ _ _ _ _ 2 Installing your new appliance_ _ _ _ _ _ 8 Description of the appliance _ _ _ _ _ _13 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _14 Using your appliance_ _ _ _ _ _ _ _ _ _16 Helpful and hints and tips _ _ _ _ _ _ _ 16 Cleaning and care _ _ _ _ _ _ _ _ _ _ _ 18 Troubleshooting_ _ _ _ _ _ _ _ _ _ _ _ _20 Disposal of the appliance_ _ _ _ _ _ _ _ 22 This appliance is in accordance with the following EU guidelines: 2014/35/EU and 2014/30/EU and 2009/125/EC and (EC) No 643/2009 and 2011/65/EU. For your safety and correct usage, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to make sure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and be sure that they remain with the appliance if it is moved or sold, so that anyone, using it throughout its life, will be properly informed on usage and safety notices. [. . . ] Open the upper door to take out all door racks(to avoid damage) and then close the door. Please slightly squeeze the door rack from two sides toward centre and inside of door rack, and then move it upward when taking out. Remove the 3 screws which are used for fixing the right upper hinge part (see the picture below) and take down the upper hinge parts Loosen the hinge axle with monkey wrench and change it to the reverse hole site , and then tighten into position. Please hold the upper door in place during step 3 to prevent the door dropping. Remove screw cover from the left-front corner of cabinet with thin-blade screwdriver and install it to the right-front corner. Remove the upper door from the middle hinge by carefully lifting the door straight up. Loose screw and take down part and part , Install replacement door stopper-left provided (in the plastic bag) and part (stop block) to the left side with screw. Door stopper Stop block Self-tapping screw Loosen screws used to fix the middle hinge and remove middle hinge. Change screw hole covers and screw on middle cover plate from left to right (as shown in figure below). Loose screw and take down part and part , Install replacement door stopperleft provided (in the plastic bag) and part (stop block) to the left side with screw . Door stopper Stop block Self-tapping screw Tip the refrigerator back wards, remove part and then remove screws. Lower hinge part (right) Front foot fixed board Adjustable bottom feet part Self-tapping screws Adjustable bottom feet part 11. Remove part from the lower hinge pin, loose out the lower hinge pin, change it to the reverse hole site, and then tighten into position, then install part on the lower hinge pin. Remove part from the part, then remove screws, screw part to the reverse hole site. Front foot fixed board Adjustable bottom feet part Self-tapping screws Replace the items remount in step 11 and step 12, change part to left and part to right and then fix them with screws . Door, then fit the hinge pin into the hinge hole at the top or the door to secure the door in place. (Please carefully hold upper door by hand when installing) Stand the refrigerator upright and carefully slot the lower door onto the bottom hinge pin and hold in position. Turn the middle hinge by 180°, change the washer on the axis to the lower side, adjust the middle hinge to the appropriate position and then install it ensuring the lower door in secured in place. Carefully slot the upper door onto the middle hinge pin and hold in position. Assemble the hinge cover-left provided (in the plastic bag) to match the hinge, install the door racks to original position. When the holiday function is activated, the temperature of the refrigerator will be automatically switched to 15 to minimize the energy consumption. When holiday function is on, you can switch it off by pressing the middle part of button. [. . . ] Only after the interior is completely dry should the appliance be switched back on and plugged back into the mains socket. Sticky food and drinks can cause seals to stick to the cabinet and tear when you open the door. Only after the door seals are completely dry should the appliance be powered on. Replacing the LED light: Warning: The LED light should be replaced by a competent person. [. . . ]