User manual HISENSE RB327N4AD2

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual HISENSE RB327N4AD2. We hope that this HISENSE RB327N4AD2 user guide will be useful to you.


HISENSE RB327N4AD2 : Download the complete user guide (9014 Ko)

Manual abstract: user guide HISENSE RB327N4AD2

Detailed instructions for use are in the User's Guide.

[. . . ] Bewegliche Regale / Tabletts Various glass, plastic storage shelves or wire trays are incIuded with your appIiance-different models have different combinations and different models have different features. The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. Safety and warning information For your safety and correct usage, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to make sure that all people using the appliance are thoroughly familiar with its operation and safety features. [. . . ] Loose screwand part, then Install them to the left side and tighten securely. Stop block Self-tapping screw Stop block Self-tapping screw Change screw hole covers on middle cover plate from left to right(as shown in figure below). Unscrew the two special flange selftapping screws which are used for fixing the middIe hinge part, then remove the middle hinge part that hold the Iower door in place. Note:When removing the door, watch for washer(s) between the Iower hinge and the bottom of the lower door that may stick to the door. Press the right side of the door shelf inwardly, while holding the left side. When the notch of the shelf has been detachesd from the refrigerator door, remove the rack obliquely upwardly. Remove and install the door shelf Warning:The door shelf must not removed and installed by the user!Lf the door shelf is damaged, contact the customer helpline for assistance. To replace the door shelf, the below steps can be followed: control panel Use your appliance according to the following control regulations, your appliance has the corresponding functions as the control panels showed in the pictures below. On hot summer days) and a colder setting can cause the compressor to run Firstly tilt the left side of the door shelf, and make sure the notch has been fastened to the door. So we do not advise the user set the temperature control knob at"colder" or "cold" in normal. Reason:when the ambient temperature is high, the compressor must run continuously to maintain the low temperature in the appliance. Energy saving tips We recommend that you follow the tips below to save energy. Try to avoid keeping the door open for long periods in order to conserve energy. Ensure the appliance is away from any sources of heat (Direct sunlight, electric oven or cooker etc) Don't set the temperature colder than necessary. If the diagram shows the correct combination for the drawers, crisper and shelves, do not adjust the combination as this is designed to be the most energy efficient configuration. Hints for fresh food refrigeration Do not place hot food directly into the refrigerator or freezer, the internal temperature will increase resulting in the compressor having to work harder and will consume more energy. Hints for refrigeration Meat (All Types) Wrap in polythene food: wrap and place on the glass shelf above the vegetable drawer. Always follow food storage times and use by dates suggested by manufacturers. Fruit and vegetables: They should be stored in the special drawer provided. Hints for freezing When first starting-up or after a period out of use, let the appliance run at least 2 hours on the higher settings before putting food in the compartment. Prepare food in small portions to enable it to be rapidly and completely frozen and to make it possible to subsequently thaw only the quantity required. [. . . ] Correct Disposal of this product This symbol on the product or in its packing indicates that this product may not be treated as household waste. Instead, it should be taken to the appropriate waste collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by the inappropriate waste handling of this product. For more detailed information about the recycling of this product, please contact your local council your household waste disposal service, or the shop where you purchased the product. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE HISENSE RB327N4AD2




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual HISENSE RB327N4AD2 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.