User manual HISENSE FV341N4BC2

[. . . ] CE notice This product has been determined to be in compliance with the Low Voltage Directive(2006/95/EC), the Electromagnetic Compatibility Directive(2004/108/EC)and the Eco-Design Directive(2009/125/EC) implemented by Regulation(EC) No 643/2009 of the European Union. Before you use the appliance, we recommend that you read through these instructions carefully, which provides details about its usage and functions. Please ensure that all people using this appliance are familiar with its operations and safety features. It is important that you install the appliance correctly and pay attention to the safety instructions carefully. [. . . ] Note 2:Install the handle cover as the follow figure shows :button the buckle firstly , and then close the cover from the inside until you hear the sound of "popping" . Lower hinge partleft Front foot fixed board Adjustable bottom feet part Self-tapping screws Note: washer may stick to the door. Screw out lower hinge, change it to the near hole site, and then screw up and mount washer. Just remount to the step 6, change partto right and partto left and then fix them with screws . Note 1:Remove the handle cover as the follow figure shows :bend the upper wing and take the upper buckle apart from the handle, and so As the other side, after that take Screw out the upper hinge axis, turn the upper hinge over and fix axis on it. Reverse part by 180°and install it onto the left corner of the door then mount part. (both of which are taken down in step 2) Exchange wires both in the left and right slots of refrigerator body. Move the door to appropriate position, adjust part and the door, Move the connecting wire in the slot of the door from left to rightand then fix part and wire by screws . (Please hold the door by hand when installing) Take the reed switch out of the coping block(partin step 3)and mount it on another block for use (which is with mark "L" in the plastic bag). Connect electrical connector in accordance with step 3 and then install part(which is in the plastic bag). Ice storage box View of the appliance RS-34WC4SIA/CSA2 Part Top LED light Twist ice maker Ice cube tray Small storage box Note: Due to unceasing modification of our products, your refrigerator may be slightly different from this instruction manual, but its functions and using methods remain the same. To get more space in the freezer, you can remove drawers (except lower freezer drawer), installtion bracket and integrative ice maker/twistable ice tray. Use your appliance according to the following control regulations, your appliance has the corresponding functions and modes as the control panels showed in the pictures below. When the appliance is powered on for the first time, the backlighting of the icons on display panel starts working. If no buttons have been pressed and the doors are closed, the backlighting will turn off. Controlling the temperature We recommend that when you start your refrigerator for the first time, the temperature for the refrigerator is set to -18°C. When you set a temperature, you set an average temperature for the whole refrigerator cabinet. In case of temperature alarm, buzzer will sound constantly for 10 times and then stop automatically. In case of temperature alarm, press "Alarm" button for 3 seconds to check the highest freezer temperature. The temperature value and "Alarm" icon will simultaneously flash for 5 seconds. When power is restored, it is normal that the temperature alarm appears, this can be cleared by pressing "Alarm". If you want to clean the appliance or stop using it, you can turn the appliance off by pressing "Power" button. [. . . ] If you experience a problem with your appliance or are concerned that the appliance is not functioning correctly, you can carry out some easy checks before calling for service, please see below. You can carry out some easy checks according to this section before calling for service. If the problem persists after you have made the checks mentioned below, contact a qualified electrician, authorized service engineer or the shop where you purchased the product. Check whether the power cord is plugged into the power outlet properly. [. . . ]