User manual HILTI TE80-ATC

[. . . ] TE 70 / TE 70-ATC / TE 80-ATC Bedienungsanleitung Operating instructions Mode d'emploi Manual de instrucciones Istruzioni d'uso Gebruiksaanwijzing Brugsanvisning Bruksanvisning Bruksanvisning Käyttöohje Manual de instruções Lietoßanas pamåcîba Instrukcija Kasutusjuhend de en fr es it nl da no sv fi pt el lv lt et 1 2 3 6 4 5 4 5 3 2 6 7 8 TE 80ATC/ TE 70ATC/ TE 70 combi hammer It is essential that the operating instructions are read before the power tool is operated for the first time. Always keep these operating instructions together with the power tool. Ensure that the operating instructions are with the power tool when it is given to other persons. Contents 1. EC declaration of conformity Page 17 18 20 20 22 25 25 27 28 29 30 30 1 These numbers refer to the corresponding illustrations. [. . . ] Do not touch the supply cord or extension cord if it is damaged while working. Damaged supply cords or extension cords present a risk of electric shock. c) Dirty or dusty power tools which have been used frequently for work on conductive materials should be checked at regular intervals at a Hilti Service Center. Under unfavorable circumstances, dampness or dust adhering to the surface of the power tool, especially dust from conductive materials, may present a risk of electric shock. d) When working outdoors with an electric tool check to ensure that the tool is connected to the electric supply by way of a ground fault circuit interrupter (RCD) with a rating of max. 30 mA The user and any other persons in the vicinity must wear suitable eye protection, a hard hat, ear protection, protective gloves and breathing protection while the power tool is in use. 24 6. Slide the side handle clamping band over the chuck and onto the cylindrical section at the front end of the power tool. CAUTION Check that the clamping band is engaged in the groove provided on the power tool. 6. 2 Use of extension cords and generators or transformers Please refer to section 2 "Description". 6. 1 Fitting and adjusting the side handle 2 1. Release the side handle clamping band by turning the handle counterclockwise. en 7. Check that the sealing lip of the dust shield is clean and in good condition. Clean the dust shield if necessary or have it replaced if the sealing lip is damaged. Push the insert tool into the chuck and rotate it while applying slight pressure until it engages in the guide grooves. Push the insert tool further into the chuck until it is heard to engage. 7. 2 Operation CAUTION In accordance with the applications for which it is designed, the power tool produces a high torque. The user must be prepared for sudden sticking and stalling of the insert tool. CAUTION The collar at the front end of the gearing section is not to be used as a gripping surface. 7. 1 Preparing for use CAUTION Wear protective gloves when changing insert tools as the insert tools get hot during use. Check that the connection end of the insert tool is clean and lightly greased. Clean it and grease it if necessary. CAUTION Working on the material may cause it to splinter. Exposure to noise can cause hearing loss. the drill bit or chisel into contact with the workpiece and allow the power tool to run under no load until it reaches the minimum operating temperature. If necessary, repeat this procedure until the hammering mechanism begins to operate. [. . . ] When the motor has stopped, move the function control switch to the "Drilling without hammering" or "Hammer drilling" position. Release the side handle and refit it correctly so that the clamping band and side handle engage in the groove. The power tool doesn't start and the LED blinks red. The power tool doesn't start and the indicator lamp blinks yellow. The power tool doesn't achieve full power. A fault has occurred in the power tool. [. . . ]