User manual HILTI TE5

[. . . ] Don't force small tool or attachment to do the job of a heavy-duty tool. Don't use tool for purpose not intended ­ for example ­ d'ont use circular saw for cutting tree limbs or logs. Rubber gloves and non-skid footwear are recommended when working outdoors. [. . . ] If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way. Please read and take note of these precautions before you use the tool/machine and keep these safety precautions in a safe place! Not recommended 17. When tool is used outdoors, use only extension cords intended for use outdoors and so marked. Before further use of the tool, a SAVE THESE INSTRUCTIONS Hilti TE 5 Rotary Hammer Technical data Power input: Voltage (versions): Current input: Frequency: Weight: Speed under load: Hammering speed under load: Single impact energy: Drill bit diameter range: Recommended range: Drilling performance in B35 concrete: 500 W 230 V 115 V 2. 3 A 4. 6 A 50­60 Hz 2. 8 kg / 6. 2 Ibs 0­800 r. p. m. 0­4000 blows per minute 2. 0 joules / 1. 5 ft-lb 5­20 mm (3/16­3/4) dia. (1. 46 in. 3) = 480 mm/min. Double insulation Accessories and kit for Hilti TE5 rotary hammer: Hilti lubricant spray, key-type chuck, quick-release chuck, case or cardboard box dust shield During operation, the sound pressure level may exceed 85 dB (A). In such case, it may be necessary to take suitable protection against the noise. Before beginning work: When working with the machine, it must be held with two hands. Check that the electric supply corresponds to the information on the rating plate. Do not apply excessive pressure to the TE 5 ­ hammering/impact power will not be increased. Before starting to work, please read the enclosed safety precautions. Drill bits in standard programme: TE-C drill bits 4­16 mm (5/32­5/8) dia. Chuck TE-C Carbon brushes with automatic cut-out Double insulation, class II Slip-type clutch as protection against motor overloading Sealed against dust, permanent lubrication (maintenance free) Variable speed control switch with infinite regulation Reversing switch Adjustable side handle with depth gauge Automatic hammering cut-out when idling Setting lever for hammer drilling/rotary drilling only Right of technical modifications reserved. This Product is Listed by Underwriters Laboratories Inc. Always wear safety glasses. 1 Cleaning the drill bit The chuck is not included in the machine's lubrication system. The drill bit connection end should therefore be cleaned at regular intervals and sprayed sparingly with Hilti lubricant spray, which is available as an accessory. Start-up time at low temperatures Start-up time can be reduced by jolting the drill bit against the work surface when switching on. rotation, the setting lever must be in the rotary drilling position (no hammering action). [. . . ] Drilling without hammering action Adjust the setting lever to the rotary drilling position ( symbol). When set to this position, only the rotary action is transmitted to the drill bit. Fig. 3: Reversing switch The desired direction of rotation for screwdriving can be selected with the reversing switch. [. . . ]