User manual HILTI TE 75

[. . . ] Ensure that the operating instructions are with the power tool when it is given to other persons. Contents 1. EC declaration of conformity Page 17 18 20 20 21 24 25 28 29 30 30 31 Operating controls and parts 1 @ Chuck ; Function selector switch = Control switch % Forward / reverse switch & Side handle with depth gauge ( Interface for TE DRS M dust removal module ) Battery + Release buttons en 1. General information 1. 1 Safety notices and their meaning WARNING Draws attention to a potentially dangerous situation that could lead to serious personal injury or fatality. CAUTION Draws attention to a potentially dangerous situation that could lead to slight personal injury or damage to the equipment or other property. 17 NOTE Used to draw attention to an instruction or other useful information. [. . . ] 6. 2. 1 Charging a new battery for the first time A new battery must be charged correctly for the first time before use. This will ensure that the cells 24 only the Hilti batteries intended for use with this power tool. Push the battery into the power tool from the rear until it is heard to engage with a double click. CAUTION A falling battery may present a risk of injury to yourself or others. 6. 5 Fitting the side handle 4 CAUTION Remove the depth gauge from the side handle in order to avoid injury. Set the forward / reverse switch to the middle position or remove the battery from the power tool. 2. Release the side handle clamping band by turning the handle counterclockwise. Slide the side handle clamping band over the chuck and onto the cylindrical section at the front end of the power tool. 6. 6 Use of the belt adapter NOTE The working weight of the power tool can be reduced by fitting an accessory belt adapter. NOTE The belt adapter cannot be used in conjunction with Li ion batteries. Observe the instructions given in the section "Safety rules" on safe use of the belt adapter. en 7. Bring the drill bit into contact with the base material and allow the power tool to run under no load until the minimum operating temperature is reached. If necessary, repeat this procedure until the hammering mechanism begins to operate. Turn the function selector switch until it engages in the "Drilling without hammering" position. Do not operate the function selector switch while the motor is running. Bring the side handle into the desired position and check that it is fitted correctly and secured. Position the power tool and drill bit at the point where the hole is to be drilled. Press the control switch slowly (drill at a low speed until the drill bit centers itself in the hole). Adjust the pressure applied to the power tool according to the material you are working on. Turn the function selector switch until it engages in the "Hammer drilling" position. Do not operate the function selector switch while the motor is running. Bring the side handle into the desired position and check that it is fitted correctly and secured. [. . . ] When the motor has stopped, move the function control switch to the "Drilling without hammering" or "Hammer drilling" position. The control switch can't be pressed, i. e. The battery doesn't engage with an audible double click. The function selector switch is set to "Drilling without hammering". The forward / reverse switch is in the middle position (transport lock engaged). The retaining lugs on the battery are dirty. The power tool or the battery gets very warm. Electrical fault. The power tool has been overloaded (application limits exceeded). [. . . ]