User manual HILTI TE 1500-AVR

[. . . ] TE 1000-AVR / TE 1500-AVR Operating instructions Mode d'emploi Manual de instrucciones Manual de instruções en fr es pt 1 This Product is Certified Ce produit est certifié Este producto esta certificado Este produto está certificado C US 2 3 4 5 6 7 8 9 10 11 ORIGINAL OPERATING INSTRUCTIONS TE 1000AVR / TE 1500AVR Breaker It is essential that the operating instructions are read before the power tool is operated for the first time. Always keep these operating instructions together with the power tool. Ensure that the operating instructions are with the power tool when it is given to other persons. Contents 1. Manufacturer's warranty - tools Page 1 2 4 5 6 9 9 11 12 13 14 1 These numbers refer to the corresponding illustrations. [. . . ] Do not touch the supply cord or extension cord if it is damaged while working. Damaged supply cords or extension cords present a risk of electric shock. Dirty or dusty power tools which have been used frequently for work on conductive materials should be checked at regular intervals at a Hilti Service Center. Under unfavorable circumstances, dampness or dust adhering to the surface of the power tool, especially dust from conductive materials, may present a risk of electric shock. Hold power tool by insulated gripping surfaces when performing an operation where the fastener may contact hidden wiring or its own cord. Fasteners contacting a "live" wire may make exposed metal parts of the power tool "live" and could give the operator an electric shock. When working outdoors with an electric tool check to ensure that the tool is connected to the electric supply by way of a ground fault circuit interrupter (GFCI) with a rating of max. Use of a ground fault circuit interrupter reduces the risk of electric shock. Use of a ground fault circuit interrupter (GFCI) with a maximum tripping current of 30 mA is recommended. Switch the power tool off and unplug the supply cord in the event of a power failure or interruption in the electric supply. This will prevent accidental restarting when the electric power returns. 8 5. 2. 4 Work area a) Ensure that the workplace is well ventilated. Exposure to dust at a poorly ventilated workplace may result in damage to the health. Objects which could cause injury should be removed from the working area. c) If the work involves breaking right through, take the appropriate safety measures at the opposite side. Parts breaking away could fall out and / or fall down and injure other persons. d) Approval must be obtained from the site engineer or architect prior to beginning the work. Work on buildings and other structures may influence the statics of the structure, especially when steel reinforcing bars or load-bearing components are cut through. en 6. Relax the tension on the side handle clamping band and slide it over the chuck and onto the cylindrical section at the front end of the power tool. 6. 2 Unlocking the power tool (theft protection system) See section "Operation / TPS Theft Protection System (optional)". 6. 3 Use of extension cords and generators or transformers See section "Description / use of extension cords". 6. 1 Fitting and adjusting the side handle 2 1. Operation 7. 1. 1 Fitting the chisel or other tool 3 NOTE The chisel can be adjusted to 6 different positions (in 60° increments). This ensures that flat chisels and shaped chisels can always be set to the optimum working position. [. . . ] Have it checked by a trained electrical specialist and replaced if necessary. 12 Fault The power tool doesn't start. Possible cause Generator with sleep mode. Remedy Apply a load to the generator by connecting another appliance (e. g. See section: 7. 2. 2 Chiseling If necessary, the power tool should be repaired by Hilti Service. Use an extension cord of an approved length and / or of adequate gauge. Pull the chuck back as far as it will go and remove the insert tool. No hammering action. The power tool is too cold. en The power tool doesn't start and the LED lights red. [. . . ]