User manual HILTI TE 106

[. . . ] TE 106 Bedienungsanleitung Operating instructions Mode d'emploi Istruzioni d'uso Manual de instrucciones de en fr it es 1 1 2 4 5 TE 1 06 3 6 06 TE 1 2 3 3 1 4 1 5 2 2 1 3 4 5 1 3 2 1 2 3 4 6 7 1 2 4 3 8 9 2 1 1 3 3 2 10 1 2 4 TE 106 breaker It is essential that the operating instructions are read before the power tool is operated for the first time. Always keep these operating instructions together with the power tool. Ensure that the operating instructions are with the power tool when it is given to other persons. Contents 1. EC declaration of conformity Page 15 16 18 18 19 22 22 24 25 25 26 26 Operating controls and parts 1 @ Chuck ; Function selector switch = Control switch % Switch lock & Front grip surface ( Rear grip surface en 1. [. . . ] c) Always hold the power tool securely with both hands on the grips provided. e) Improve the blood circulation in your fingers by relaxing your hands and exercising your fingers during breaks between working. f) Always lead the supply cord and extension cord away from the power tool to the rear while working. The workpiece is thus held more securely than by hand and both hands remain free to operate the power tool. b) Check that the insert tools used are compatible with the chuck system and that they are secured in the chuck correctly. c) Switch the power tool off and unplug the supply cord in the event of a power failure or interruption in the electric supply. This will prevent accidental restarting when the electric power returns. 5. 2. 3 Electrical safety b) Check the power tool's supply cord at regular intervals and have it replaced by a qualified specialist if found to be damaged. Check extension cords at regular intervals and replace them if found to be damaged. Do not touch the supply cord or extension cord if it is damaged while working. Damaged supply cords or extension cords present a risk of electric shock. c) Dirty or dusty power tools which have been used frequently for work on conductive materials should be checked at regular intervals at a Hilti Service Center. 7. 2 Operation DANGER Always hold the power tool securely with both hands on the grips provided. 7. 1 Preparation 7. 1. 1 Fitting the insert tool 2 CAUTION Wear protective gloves when changing insert tools as the insert tools get hot through use and they may have sharp edges. Check that the connection end of the insert tool is clean and lightly greased. Push the insert tool into the chuck and rotate it while applying slight pressure until it engages in the guide grooves. Push the insert tool further into the chuck until it is heard to engage. 7. 1. 2 Removing the insert tool 3 CAUTION Wear protective gloves when changing insert tools as the insert tools get hot through use and they may have sharp edges. Flying fragments may cause injury to the eyes or other parts of the body. Wear eye protection, protective gloves and breathing protection if no dust removal system is used. Wear ear protection. 7. 2. 1 Chiseling 6 NOTE Working at low temperatures: The hammering mechanism works only when the power tool has reached a minimum operating temperature. Bring the chisel into contact with the base material and allow the power tool to run under no load until the minimum operating temperature is reached. [. . . ] See section: 7. 2. 1 Chiseling 6 Use an extension cord with an adequate conductor cross section. (Please refer to "Before use". ) Press the control switch as far as it will go. Pull the chuck back as far as it will go and remove the insert tool. en Other electrical fault. The power tool doesn't achieve full power. The power tool is too cold. The extension cord's conductor cross section is inadequate. [. . . ]