User manual HILTI SF180-A

[. . . ] SF180-A en Operating instructions 9­16 375007 *375007* 1 7 4 8 153 2 9 6 2 L STOP R 3 2 1 4 1-13 5 7 9 11 13 5 6 7 SF 180-A hammer drill driver 1. General information It is essential that the operating instructions are read before the tool is operated for the first time. Ensure that the operating instructions are with the tool when it is given to other persons. 1. 1 Indication of danger -CAUTIONUsed to draw attention to a potentially dangerous situation which could lead to minor personal injury or damage to the equipment or other property. -NOTEUsed to draw attention to an instruction or other useful information. [. . . ] Failure to observe this point may present considerable risk to the user. q Ensure that the outer surfaces of the battery are clean and dry before inserting it in the corresponding charger. q Use only the batteries listed in these operating instructions (see section 6). q Batteries that have reached the end of their life must be disposed of safely (see section 10). q Ensure that batteries are charged using the correct charger recommended by the manufacturer. Incorrect use may result in a risk of electric shock, overheating or leaking of corrosive liquid from the battery. You should therefore wear protective gloves when changing insert tools. It is essential that the safety precautions printed in these operating instructions are read and observed. A new battery must be charged correctly for the first time before use: ­ charged normally for 24 hours with the SFC 7/8 H charger, or ­ charged for 12 hours using the conditioning function of the SFC 7/18 or TCU 7/36 charger This will ensure that the cells form correctly. Incorrect initial charging may have a permanent, negative effect on battery capacity. -NOTE­ The tool may be used only with SFB 180 or SFB 185 batteries. ­ Never store batteries where they are exposed to the heat of the sun, on a radiator, behind a motor vehicle windscreen or at a window. Change to the second battery as soon as a drop in performance is noticed and recharge the battery immediately so that it is ready for re-use. Open the side handle clamping band by turning the handle. q A caustic liquid may leak from defective batteries. In the event of contact with the skin, wash the area affected with soap and plenty of water. 7. 2 Setting the speed (2-speed gear selector switch) -CAUTIONOperate the gear selector switch only when rotation has stopped. 7. 3 Screwdriving Set the desired direction of rotation by way of the forward / reverse switch. 7. 3. 1 Torque setting Set the torque by turning the torque clutch setting ring to the desired torque setting (1­13). The battery cannot be charged through the belt adaptor. Incorrect use may lead to electric shocks, overheating of the battery or leakage of a caustic liquid from the battery. Read the operating instructions for the charger before beginning charging. 7. 10 Changing the bit -CAUTIONs The insert tool may become hot during use. Care and maintenance 8. 1 Care of insert tools Remove any dirt adhering to the surface of the insert tools and protect them from corrosion by rubbing them with an oily cloth from time to time. [. . . ] This warranty provides the free-of-charge repair or replacement of defective parts only. Parts requiring repair or replacement as a result of normal wear and tear are not covered by this warranty. Additional claims are excluded, unless stringent national rules prohibit such exclusion. In particular, Hilti is not obligated for direct, indirect, incidental or 16 consequential damages, losses or expenses in connection with, or by reason of, the use of, or inability to use the tool for any purpose. [. . . ]