User manual HILTI SD2500

[. . . ] Description 2. 1 Use of the tool as directed The ST 2500 is a hand-held, electric mains-powered tool for driving screws used to fasten sheet metal in metal construction applications. The SD 2500 is a hand-held, electric mains-powered tool for driving screws used in timber construction and drywall installation applications. The tools are used for driving or removing the recommended screws in the applicable materials. Provision has been made for use of a magazine (SMI 55 plus) with the SD 2500. [. . . ] Avoid contact between your body and earthed / grounded objects, such as pipes or radiators. External metal parts of the tool may become live, for example, when an electric cable is drilled into inadvertently. 5. 3 General safety precautions Follow the instructions concerning care and maintenance. Check that the insert tools used are compatible with the chuck system and that they are secured in the chuck or gear housing correctly. Use the right electric tool for the job. Use only the original accessories or ancillary equipment listed in the operating instructions. Use of other 5. 3. 2 Electrical hazards Protect yourself against electric shock. pipes, radiators, cookers and fridges. 12 Check the condition of the supply cord at regular intervals and, if found to be damaged, have it replaced by a trained electrical specialist. Check the condition of extension cords at regular intervals and replace them if found to be damaged. Do not operate the tool if it is found to be damaged, if it is not complete or if its controls cannot be operated faultlessly. Do not touch the supply cord in the event of it suffering damage while working. The tool may be repaired by trained electrical specialists only (Hilti service) using original Hilti spare parts. Failure to observe this point may present considerable risk to the user. Do not use the supply cord for purposes for which it is not intended. When working outdoors, use only extension cords approved and correspondingly marked as suitable for outdoor use. In the event of a power cut: Switch off and unplug the tool. Avoid using extension cords with multiple sockets for simultaneous use of several electric tools or appliances. Dust or dampness on the surface of the tool make it difficult to hold and, under unfavorable conditions, may lead to electric shocks. 5. 4 Requirements to be met by users The tool is intended for professional use. The tool may be operated, serviced and repaired only by authorized, trained personnel. The depth gauge can be adjusted to ensure correct compression of the sealing washer under the head of the screw. Compression of the screw seal is increased (± 0. 25 mm per click stop) (III). 7. 5. 2 Adjusting the SD 2500 depth gauge By adjusting the depth gauge, the screw head can be driven flush, countersunk or left projecting (± 0. 25 mm per click stop) (III). 7. 7 Changing bits 7. 7. 1 Changing bits with the ST 2500 The chuck is of the 1/4 hexagon type (for sockets, bit holders, bits, etc. ). The sockets, bit holders and bits are retained in the chuck by a sliding sleeve mechanism. 7. 7. 2 Changing bits with the SD 2500 The chuck is of the 1/4 hexagon type (for bit holders, bits, etc. ). [. . . ] This warranty provides the free-of-charge repair or replacement of defective parts only. Parts requiring repair or replacement as a result of normal wear and tear are not covered by this warranty. Additional claims are excluded, unless mandatory national rules prohibit such exclusion. In particular, Hilti is not obligated for direct, indirect, incidental or consequential damages, losses or expenses in connection with, or by reason of, the use of, or inability to use the tool for any purpose. [. . . ]