User manual HILTI SBC12H

[. . . ] SB 12, SBC 12 H, SBP 12 Bedienungsanleitung Operating instructions Safety precautions Caution: The following fundamental safety precautions must always be observed when using electric tools/machines as protection against and electric shock, the risk of injury and fire hazards. Please read and take note of these precautions before you use the tool/machine. Keep these safety precautions in a safe place! 1 Keep your place of work clean and tidy. Disorder where you are working creates a potential risk of accidents. (Please read and keep these instructions) ed, e. g. [. . . ] This permits, for example, screws to be driven to an even depth for optimum appearance. Battery release button (2-finger operation) To remove ther battery, press the battery release buttons and pull the SB12 battery out of the screwgun. Quick-release chuck (1. 5­13 mm) The insert tool can be inserted or removed without the use of a chuck key. A locking device prevents rotation of the motor spindle when the control switch is in the OFF position. This feature is of assistance when tightening or opening the chuck. Care and maintenance The gearing section has been filled with sufficient grease during assembly. If used heavily over a long period of time, it is recommended that the screwgun is returned to Hilti for inspection. This can extend the life of the screwgun and avoid unnecessary repair costs. If an excessive amount of dust collects, clean the screwgun by blowing out dust with a jet of compessed air. Servicing may only be carried out by a recognised electrical specialist. Optimum safety can be ensured by using only original Hilti spare parts. This warranty provides the free-of-charge repair or replacement of defective parts only. Parts requiring repair or replacement as a result of normal wear and tear are not covered by this warranty. Additional claims are excluded, unless stringent national rules prohibit such exclusion. In particular, Hilti is not obligated for direct, indirect, incidental or consequential damages, losses or expenses in connection with, or by reason of, the use of, or inability to use the tool for any purpose. Implied war- ranties of merchantability or fitness for a particular purpose are specifically excluded. For repair or replacement, send the tool and/or related parts immediately upon discovery of the defect to the address of the local Hilti marketing organization provided. Battery charged - red LED blinks (short intervals) Screwgun - See SB 12 operating instructions. Red LED charging indicator blinks (short intervals) The LED charging indicator blinks at short intervals when the battery has been charged. A trickle charging current flows to the battery during this phase of the charging cycle. Battery compartment The SBP12 battery clicks into position in the battery compartment ensuring that correct contact is made. Safety Important The enclosed list of safety precautions must be observed! Do not use this product in any way other than as directed by these operating instructions. The mains supply voltage must correspond to the information printed on the rating plate. 230-volt units can also be connected to 220 and 240-volt mains supplies. This charger should be used only for charging the Hilti SBP12 or SBP10 batteries. [. . . ] This allows the battery cells to become balanced. The SBP 12 battery can be recharged more than 1000 times! The SBP 10 battery will not suffer damage even when left in the charger for long periods. Care and maintenance The contacts must be kept free of dust, oil and grease. If battery capacity drops below an acceptable level after it has been used for a long period, we recommend that the battery be returned to Hilti for testing. Servicing may only be carried out by a recognised electrical specialist. [. . . ]