User manual HILTI RM 710 EP

[. . . ] 7. 2. 4 RM 800 PC Cement Repair Mortar Construction Chemicals Construction Chemicals 7. 2. 3 RM 710 EP Lo-Temp Mortar 7. 2. 3. 4 Installation Instructions Surface Preparation The surface to be repaired must be clean, dry, and free of oil, grease and loose matter. The bonding surface should be roughened, using a small chipping hammer or bushing tool, swept clean and blown with clean, dry, oil-free compressed air, or vacuumed clean. [. . . ] Do not mix more mortar than can be applied in 30 minutes at 35°F (2°C), or 5 minutes at 70°F (21°C). Drain the contents of Part B completely into a clean mixing container. Next, add the aggregate, a little at a time, while mixing with a mortar mixer or a drill with a mixing paddle. Mix until uniform, being sure that there is no dry aggregate on the bottom or sides of the pail. Failure to combine components in the proper ratios can result in poor cure or no cure. Troweling For large patches, apply RM 710 EP mortar in 2 foot wide strips. Spread and finish with a rectangular steel trowel, taking care to minimize trowel marks. Trowels may be coated with a commercial solvent such as mineral spirits, to give the finished work a smoother appearance. Maintenance RM 710 EP may be cleaned with most floor cleaning detergents. Floor Cleaning Caution: Some cleaners may affect the color of the floor installed. [. . . ] Description Size 00020268 00020429 00024155 RM 710 EP 65 lb pail RM 710 EP Sample Kit 9 lb unit Stainless Steel Paddle Mixer smooth shank (shown below) Specially designed for epoxy mortar. (US) 1-800-879-8000 | www. us. hilti. com I en español 1-800-879-5000 I Hilti (Canada) Corp. [. . . ]