User manual HILTI PR60

[. . . ] PR 60 / PA 350 GB Operating instructions F Mode d'emploi 1­ 50 51­100 *338416* 338416 Operating Instructions PR 60 / PA 350 PR 60 rotating laser / PA 350 detector Symbols used The symbols used in these operating instructions have the following meanings: WARNING Usage risk or incorrect use which could lead to severe personal injury of a fatal accident. CAUTION Usage risk or incorrect use which could lead to only minor personal injury but considerable damage to property or the environment. Usage information which helps the user to employ the instrument efficiently and in a technically correct manner. Besides the instructions for use, these operating instructions also contain important safety information (see "Safety instructions" section). Please read these operating instructions carefully before operating the tool for the first time. [. . . ] This may lead to serious injury to themselves or to a third party and to pollution of the environment. Most of the materials from which Hilti tools are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking back old tools for recycling. Please ask your Hilti customer service department or Hilti representative for further information. Safety precautions Disposal, continued Part, assembly Housing, carrying case Control panel, display Liquid compensator Electronics Screws, small parts Main material Plastic Plastic Metal and oil Various Steel Recycling Plastics recycling Plastics recycling Scrap metal, old oil Electronics scrap Scrap metal 28 3. Operation and use Inserting the batteries (PR 60) 1 LED blinks: Replace the batteries The LEDs blink alternately as long as some voltage is present: Batteries are discharged; the unit cannot be operated. Inserting new batteries 4 A 1 2 5 6 3 1 Turn lever A from LOCK to OPEN. 3 Remove the old batteries and dispose of them in accordance with regulations. Operation and use Inserting the batteries (PR 60) The «low batteries» warning is detected by the PA 350 and indicated: The symbol then blinks. To deactivate the warning on the PA 350: Press and hold the "Buzzer" on. button an then press the «ON» button to switch Inserting the batteries (PA 350) The following symbols indicate the condition of the battery in the PA 350: Battery voltage is adequate. The tool will, nevertheless, continue to function (symbol alternates between charged and discharged). Remove the used battery and dispose of it in accordance with regulations. Insert the supplied 9 V block battery (or a new battery) and then push the battery holder back into the tool. Take care to ensure that as many measuring points as possible can be reached. Open the quick-release clamps on the tripod legs, pull the legs out to the required height and then close the clamps. Press the points of the tripod legs into the ground by applying foot pressure, thus ensuring that the tripod stands securely. When applying foot pressure to the tripod legs, ensure that the force applied acts towards the point of the leg. 31 3. Operation and use Setting up and operating the tool, continued When setting up the tripod, take care to ensure that the tripod top plate is approximately horizontal. The auto-levelling LED blinks, the shock warning function is activated and the remaining battery capacity is indicated. 90 sec. ), the auto-levelling LED extinguishes and the rotating head begins < 90 s to rotate at the operating speed of 600 r. p. m. [. . . ] The NiCd batteries do not have to be removed from the PR 60 before charging. For further information, please refer to the separate operating instructions. NiCd batteries 46 Battery holder Mains power supply unit 6. FCC statement (applicable in U. S. ) WARNING This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ]