User manual HILTI PM24

[. . . ] The tool levels itself automatically within 3 seconds each time it is moved. Condition The tool must be placed on a level surface with a maximum slope of 5°. To de-activate the automatic cut-out: Press and hold the ON / OFF button until the green LED begins to blink (approx. Note Press the ON / OFF button to switch off the tool after use in order to save battery power. ~3s Continued 7 1. [. . . ] Safety information Electromagnetic compatibility (EMC) Electromagnetic compatibility refers to the ability of the Hilti PM 24 to function correctly in an environment where it is exposed to electromagnetic radiation and electrostatic discharge, without causing electromagnetic interference to other devices. WARNING There may be a possibility of interference to other equipment due to electromagnetic radiation. Although the Hilti PM 24 complies with the strict requirements of the relevant directives and standards, Hilti cannot entirely rule out the possibility of interference with other equipment. CAUTION Measurements may exceed tolerances where interference is caused by powerful electromagnetic radiation. Most of the materials from which Hilti tools are manufactured can be recycled. The materials must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for taking back old tools for recycling. Please ask your Hilti customer service department or Hilti representative for further information. Safety information Disposal Part, assembly Casing On-off switch Electronics Screws, small parts Soft pouch Frame clamp PA 271 stand Wall mount Magnetic bracket PA 211/221 target plate Main material Plastic Plastic Various Steel Woven synthetic fiber Metal, steel Aluminium, metal Metal, steel Steel Plastic Recycling Plastic recycling Plastic recycling Electronics scrap Scrap metal Plastic recycling Metal Metal, plastic Metal Metal Plastic recycling 21 3. Operation and use Inserting or replacing the batteries Green indicator blinks ­ the laser beams blink for a few minutes and then switches off automatically © battery voltage too low © insert new batteries: open close Always replace the complete set of batteries!­ Do not mix batteries of different makes or use batteries of different types. 22 3. Operation and use Operating conditions 1 Observe the operating temperature range. 2 Place the tool on a level, steady surface (the floor). Accuracy of the tool can only be ensured when the operating conditions (points 1 and 2) are observed. PM 24 PM 24 23 3. Operation and use Setting up 1 PM 24 2 PM 24 Marking the reference point ­ the possibilities 1 Mark the laser reference beam point by hand. alignment with the edge of a dry wall track or board, etc. , position the PM 24 against the track. The laser reference beam spot is positioned exactly on the edge of the track and at the center of the tool. 24 3. Operation and use Plumbing with the PM 24 Note: The other beams have been omitted from illustration for clarity. Procedure 1 Position the tool on the marked reference point. The ON indicator lights (green), the laser beam lights up and the tool levels itself automatically. 4 Mark the plumb up beam spot or use the PA 211 target plate, for example, to check for plumb along a wall. PM 24 PM 24 PM 24 25 3. Operation and use Setting out 90 ° angle with the PM 24 Procedure: 1. Using the target plate, adjust the front beam so that it is parallel to the wall. Now with the right, 90 ° beam and the target plate mark off your points. +10 mm -10 +1/2 inch -1/2 PA 221 y x1 x2 x3 x4 26 3. [. . . ] This means that only original Hilti consumables, components and spare parts may be used in the tool. (Unless stringent national rules stipulate a longer minimum warranty period. ) This warranty provides the free-of-charge repair or replacement of defective parts only. Parts requiring repair or replacement as a result of normal wear and tear are not covered by this warranty. Additional claims are excluded, unless stringent national rules prohibit such exclusion. [. . . ]