User manual HILTI HIT RM 700 EP

[. . . ] 7. 2. 3 RM 710 EP Lo-Temp Mortar Construction Chemicals Construction Chemicals 7. 2. 2 RM 700 EP Epoxy Repair Mortar 7. 2. 2. 4 Installation Instructions Surface Preparation The surface to be repaired must be clean, dry, and free of oil, grease and loose matter. The bonding surface should be roughened, using a small chipping hammer or bushing tool, swept clean and blown with clean, dry, oil-free compressed air, or vacuumed clean. [. . . ] Next, add the aggregate, a little at a time, while mixing with a mortar mixer or a drill with a mixing paddle. Mix until uniform, being sure that there is no dry aggregate on the bottom or sides of the pail. Failure to combine components in the proper ratios can result in poor cure or no cure. Troweling For large patches, apply RM 700 EP mortar in 2 foot wide strips. Spread and finish with a rectangular steel trowel, taking care to minimize trowel marks. Trowels may be coated with a commercial solvent such as mineral spirits, to give the finished work a smoother appearance. Maintenance RM 700 EP may be cleaned with most floor cleaning detergents. Floor Cleaning Caution: Some cleaners may affect the color of the floor installed. If no ill effects are noted, you can continue to clean with the product and process tested. However, if you opt to topcoat the applied mortar, allow it to cure before topcoating. [. . . ] Use with Jacob's style chuck. 65 lb pail 9 lb unit 330 Hilti, Inc. (US) 1-800-879-8000 | www. us. hilti. com I en español 1-800-879-5000 I Hilti (Canada) Corp. [. . . ]