User manual HILTI HIT-P 8000D

[. . . ] · Material Safety Data Sheet: Review the MSDS before use. Installation Instructions: Follow the pictograms 1-14 for the sequence of operations and refer to tables 1-3 for setting details. "h ef" beyond values specified in setting details), contact Hilti. Method 2 -- for water filled boreholes, submerged concrete or diamond cored boreholes: · Flush hole 2 times by inserting a water hose (water-line pressure) to the back of the borehole until water runs clear. · Brush 2 times with the specified brush size (brush Ø = borehole Ø) by inserting the round steel brush to the back of the borehole with a twisting motion and removing it. [. . . ] · Brush 2 times with the specified brush size (brush Ø = borehole Ø) by inserting the round steel brush to the back of the borehole with a twisting motion and removing it. The brush should resist insertion into the borehole -- if not, the brush is too small and must be replaced with the proper brush diameter. For diamond cored boreholes and if a dry borehole is required for injection (e. g. water flows into cleaned borehole), continue with borehole cleaning as described by methode 1. To attain a dried borehole, a Hilti HIT-DL air nozzle attachment is recommended for borehole depth up to 10 inch (250 mm) and required for borehole depth > 10 inch (250 mm). The borehole must be free of dust, debris, ice, oil, grease and other contaminants prior to adhesive injection. Never use damaged foil packs and/or damaged or unclean foil pack holders. Push release trigger, retract plunger and insert foil pack holder into the appropriate Hilti dispenser. Depending on the size of the foil pack an initial amount of adhesive has to be discarded. If a new mixer is installed onto a previously-opened foil pack, the first trigger pulls must also be discarded as described above. To ease installation, anchor/rebar may be slowly twisted as they are inserted. After installing an anchor/rebar, the annular gap must be completely filled with adhesive. If the borehole is not completely filled along the embedment depth the installation should be rejected. For overhead applications take special care when inserting the anchor/rebar. Excess adhesive will be forced out of the borehole -- take appropriate steps to prevent it from falling onto the installer. Position the anchor/rebar and secure it from moving/falling during the curing time (e. g. Observe the gel time "t gel", which varies according to temperature of base material. Minor adjustments to the anchor/rebar position may be performed during the gel time. Do not disturb the anchor/rebar once the gel time "t gel" has elapsed until "t cure, ini" has passed. Between "t cure, ini" and "t cure, full" the adhesive has a limited load bearing capacity, do not apply a torque or load on the anchor/rebar during this time. [. . . ] Do not disturb the anchor/rebar once the gel time "t gel" has elapsed until "t cure, ini" has passed. Between "t cure, ini" and "t cure, full" the adhesive has a limited load bearing capacity, do not apply a torque or load on the anchor/rebar during this time. Apply load/torque after "t cure, full" has passed, and the fixture to be attached has been positioned. or or *) Please refer to technical literature (approvals, setting instructions) for detail. 13. 14. Partly used foil packs must be used up within four weeks. Leave the mixer attached to the foil pack manifold and store under the recommended storage conditions. [. . . ]