User manual HILTI HIT-MD2000

[. . . ] General information 1. 1 Safety notices and their meaning -WARNINGDraws attention to a potentially dangerous situation that could lead to serious personal injury or fatality. -CAUTIONDraws attention to a potentially dangerous situation that could lead to slight personal injury or damage to the equipment or other property. 1. 2 Explanation of the pictograms and other information Warning signs en General warning Warning: electricity Warning: caustic substances Obligation signs Symbols Wear eye protection. Wear protective gloves. Read the operating instructions before use. Return waste material for recycling. Contents 1. EC declaration of conformity Page 11 12 12 12 13 15 16 17 17 18 19 19 These numbers refer to the corresponding illustrations. [. . . ] e) Under abusive conditions, liquid may be ejected from the battery; avoid contact. 5. 1. 6 Service a) Have your power tool serviced by a qualified repair person using only identical replacement parts. 5. 2 Additional safety precautions 5. 2. 1 Electrical safety the extension cord and replace it if damage is found. Do not touch the supply in the event of it suffering damage while working. Damaged supply cords and extension cords present a risk of electric shock. c) Do not insert the mains adaptor into the battery charger, especially when the mains adaptor supply cord is plugged into the electric supply. Exposure to dust at a poorly ventilated workplace may result in damage to the health. 5. 2. 3 Safety equipment a) The user and any other persons in the vicinity must wear suitable eye protection and protective gloves while the tool is in use. a) Mobile generators may generate an excessively high voltage. Check that the mains adaptor is operated only within the specified voltage and frequency range. b) Check the condition of the supply cord and its plug connections and have it replaced by a qualified electrician if damage is found. Push the battery into the tool from below until it is heard to engage with a click. The foil pack is opened automatically by a piercing point built into the junction piece. The 16 2 components can be seen to mix as they pass through the nozzle. The initial quantity of mortar dispensed (amount specified in the applicable instructions for use of the mortar) is not suitable for use and must be discarded. Likewise, after changing a mixing nozzle, the initial flow should be discarded. 7. 4 Injecting the mortar Note: In the single-stroke mode, keep the trigger pulled until the dispenser switches itself off. The hole must be filled with adhesive mortar without forming air pockets. To achieve this, insert the nozzle as far as the base of the hole (use the extension for deep holes) and slowly withdraw the nozzle, step by step, after each pull of the trigger. Details of the number of trigger pulls required for each anchor size are printed in the instructions enclosed with the foil pack. Important: failure to observe these instructions could negatively affect the loadbearing capacity of the fastening!Press the release button after the hole has been filled with adhesive. This releases pressure on the foil pack and no further adhesive flows from the mixing nozzle. [. . . ] Charge the battery in refresh chargemode (please refer to the operating instructions for the charger). Clean the retaining lugs and check that the battery / mains adaptor engages securely. Switch the tool off immediately, remove the battery / mains adaptor and contact Hilti Service. Use the right tool for the job (don't use a low-powered tool for heavy work). [. . . ]