User manual HILTI DX 600N

[. . . ] bore brush O4O29O4 HHl:IHhI 1 pair satety rings 0451655 Selector chart (DX400 B) 4995440 Instruction manual (DX400 B) 4995376 1 Hilti spray ubrlcanl 4804672 E!TTIf goggles 4654032 I rounc wtre brush %" 4553776 1 flat :Flfl-fl' !. [. . . ] lf a booster tails to igniie: a) Keep the lool pressed against the work surface for thirty (30) seconds. b) lf the boosterdoes not ignile, withdraw the tool approximately 2" from the work surface (to recock the tiring mechanism), taking care thal it never points at yourself or anyone else. c) Beposition the tool against the work surface, fully depress the guide, and again squeeze the trigger. d) lf the boosler still fails to ignite, wait another thirty (30) seconds, carefully remove the toolfrom the work surface, pull oui the baseplate untilthe top of the booster magazine protrudes from the top of the tool. Every reasonable precaution has been taken in the manufaciure of the tool to assure that it complies with Hilti's standard of high quality. The Hilli tool is warranted lor 5 years to the original purchaser from the date of shipment. The warranty is against defects in material or workmanship, provided that the system is used in accordance with Hilli instructions; repairs have not been made by persons olher than authorized Hilti service personnel; damage is not due to normal wear and tear; the tool has not been abused or misused: and lhe defective iool is returned to the local Hilti representative for forwarding to the Hilti Repair Center. Parts which are found lo be defective in material or workmanship will be replaced or repaired without cost other lhan the cost of shipping and insurance. [. . . ] Parts which are found lo be defective in material or workmanship will be replaced or repaired without cost other lhan the cost of shipping and insurance. [. . . ]