User manual HILTI DCG 700-P

[. . . ] DCG 700-P Operating instructions Mode d'emploi Manual de instrucciones Manual de instruções en fr es pt This Product is Certified Ce produit est homologué Producto homologado por Este produto está registrado C US 1 2 3 4 5 6 ORIGINAL OPERATING INSTRUCTIONS DCG 700P angle grinder en It is essential that the operating instructions are read before the power tool is operated for the first time. Always keep these operating instructions together with the power tool. Ensure that the operating instructions are with the power tool when it is given to other persons. Contents 1. Manufacturer's warranty - tools Page 1 2 4 5 5 10 11 13 13 14 14 1 These numbers refer to the corresponding illustrations. [. . . ] b) Do not position your body in line with and behind the rotating wheel. When the wheel, at the point of operation, is moving away from your body, the possible kickback may propel the spinning wheel and the power tool directly at you. c) When wheel is binding or when interrupting a cut for any reason, switch off the power tool and hold the power tool motionless until the wheel comes to a complete stop. Never attempt to remove the cut-off wheel from the cut while the wheel is in motion otherwise kickback may occur. Investigate and take corrective action to eliminate the cause of wheel binding. d) Do not restart the cutting operation in the workpiece. The wheel may bind, walk up or kickback if the power tool is restarted in the workpiece. e) Support panels or any oversized workpiece to minimize the risk of wheel pinching and kickback. Supports must be placed under the workpiece near the line of cut and near the edge of the workpiece on both sides of the wheel. f) Use extra caution when making a "pocket cut" into existing walls or other blind areas. The protruding wheel may cut gas or water pipes, electrical wiring or objects that can cause kickback. 5. 2. 5 Safety warnings specific for sanding operations Do not use excessively oversized sanding disc paper. Larger sanding paper extending beyond the sanding pad presents a laceration hazard and may cause snagging, tearing of the disc or kickback. 5. 2. 6 Safety warnings specific for wire brushing operations a) Be aware that wire bristles are thrown by the brush even during ordinary operation. b) If the use of a guard is recommended for wire brushing, do not allow any interference of the wire wheel or brush with the guard. Wire wheel or brush may expand in diameter due to work load and centrifugal forces. b) Always hold the power tool securely with both hands on the grips provided. c) Breathing protection must be worn if the power tool is used without a dust removal system for work that creates dust. d) Improve the blood circulation in your fingers by relaxing your hands and exercising your fingers during breaks between working. 8 e) Avoid touching rotating parts. Switch the power tool on only after bringing it into position at the workpiece. Touching rotating parts, especially rotating insert tools, may lead to injury. f) Always lead the supply cord and extension cord away from the power tool to the rear while working. h) The appliance is not intended for use by children, by debilitated persons or those who have received no instruction or training. [. . . ] Do not use a spray, steam pressure cleaning equipment or running water for cleaning. Always keep the grip surfaces of the power tool free from oil and grease. 8. 2 Maintenance WARNING Do not operate the power tool if parts are damaged, if the electronic control unit is defective or when the controls do not function faultlessly. WARNING Repairs to the electrical section of the power tool may be carried out only by trained electrical specialists. [. . . ]