User manual HILTI CP 672 INSTALLATION

[. . . ] Surfaces to which CP 672 will be applied should be cleaned of loose debris, dirt, oil, moisture, frost and wax. [. . . ] Make sure CP 672 contacts all surfaces and overlaps 1/2" beyond all surrounding surfaces. ­ Benron EZ-Tex Sprayer and Graco Texspray Compact HP pumps have been successful in applying CP 672 Firestop Joint Spray. Curing of firestop spray ­ Allow 5 to 7 days (@ 73°F) for CP 672 to fully cure 5. For maintenance reasons, joint seal could be permanently marked with an identification plate. In such a case, mark the installation plate and fasten it in a visible position next to the seal. Notice about approvals · When making a seal using Hilti CP 672 Firestop Joint Spray, please refer to the UL Directory or the Hilti Firestop Manual for restrictions as to joint size, type and thickness of wall or floor, movement capabilities, etc. · In areas underwater · On hot surfaces (above 200°F) Safety precautions · Before handling, read the Material Safety Data Sheet for detailed use and health information · Wear suitable gloves and eye protection. [. . . ] Storage · Store only in the original packaging at temperatures 40°F (5°C) to 100°F (37°C). [. . . ]