User manual HILTI CG 200 PC INSTALLATION

[. . . ] Construction Chemicals 7. 2. 5 CG 200 PC Cementitious Grout 7. 2. 5. 4 Installation Instructions Temperatures Air, mix and substrate temperatures should be between 40°F (4°C) and 90°F (32°C) during application and be protected from freezing a minimum of 48 hours after installation. [. . . ] Use procedures which permit CG 200 PC to flow by gravity between the surfaces and keep the grout in full contact with these surfaces until it has hardened. Mixing CG 200 PC may be mixed to a dry pack, hand trowel or fluid pourable consistency, depending on the amount of water added. CG 200 PC is a pre-blended grout which uses a precise blend of select silica aggregate, set accelerators, water and reducing agents, fluidizers and expansion producing admixtures. The water additions shown will provide a general guideline for achieving the desired consistency. The actual amount of water required may be affected by the temperature, batch size and mix method chosen. CG 200 PC may be mixed in a revolving concrete mixer, or in a bucket, using a Hilti drill and a mixing paddle. The method chosen should allow continuous placements, so that all the grout is in place before any of it has taken a set. Plastic, Trowel Consistency 55 lb 1. 1 gal (9. 1 lb) 0. 51 cu ft 126 lb/cu ft Fluid, Pumping Consistency 55 lb 1. 5 gal (12. 3 lb) 0. 55 cu ft 122 lb/cu ft CAUTION: Contains Silicon Dioxide, Portland Cement and Calcium Hydroxide. For eyes, flush with clean water for at least 15 minutes and get prompt medical attention. [. . . ] (US) 1-800-879-8000 | www. us. hilti. com I en español 1-800-879-5000 I Hilti (Canada) Corp. [. . . ]