User manual HILTI C7-24

[. . . ] Location of identification data on the appliance The type designation and serial number can be found on the rating plate on the appliance. Make a note of this data in your operating instructions and always refer to it when making an enquiry to your Hilti representative or service department. Description The charger is designed for charging Hilti batteries with a nominal voltage of 7. 2 ­ 36 volts (C 7/36-ACS charger) or 7. 2 ­ 24 volts (C 7/24 charger). Items supplied ­ C 7/24 standard charger or ­ C 7/36-ACS top charger ­ Operating instructions Charging time with C7/36-ACS 30 min. [. . . ] Use only the batteries listed in these operating instructions. 11 Batteries must be disposed of correctly and safely on reaching the end of their life. flush the eyes with water immediately and subsequently consult a doctor. 5. 5 Requirements to be met by users The appliance is intended for professional use. The appliance may be operated, serviced and repaired only by authorized, trained personnel. This personnel must be informed of any special hazards that may be encountered. Stay alert. 5. 4. 2 Liquids en Caustic liquids may leak from defective batteries. In the event of contact with the skin, wash the area affected with soap and plenty of water. Before use 6. 2 Switching on the charger Plug the supply cord into the electric socket. The electric supply voltage must comply with the specification given on the rating plate. 6. 1 Operate the charger only at a suitable place The charger should be operated only at a dry, clean, cool place but where it is protected from frost. The charger must be able to give off heat during the charging operation. Do not operate the charger inside a closed container. -NOTEAll 3 indicator lamps light briefly while the self-test is being carried out. Should the green lamp continue to blink after the supply cord has been unplugged and then reconnected to the mains supply, the charger should be returned to a Hilti service center for repair. 7. Operation 7. 1 Inserting the battery Insert the battery in the appropriate compartment or interface, depending on the type of Hilti battery to be charged. Please use the Hilti CA 7/36 adaptor when charging BP 40, BP 72, RB 10 and BP 12, batteries (not supplied with the charger). Ensure that the shape of the battery terminal section and the adaptor correspond. The charging procedure starts automatically after the battery has been fully inserted in the charger. -NOTEThe battery will not suffer damage even when left in the charger for long periods (with the charger in operation). -CAUTIONThe charger is designed for use with the Hilti batteries listed. Charging other batteries is not permissible as this 12 may result in personal injury or serious damage to the battery. 7. 2 Indicators Green lamp lights constantly The charger is connected to the mains supply and is ready for use. blinks A malfunction in the charger or battery was detected during the selftest. blinks Battery charging is complete. Yellow lamp lights constantly The battery is being charged in refresh mode (see section 7. 3). blinks The battery is too cold (< 0°C) or too warm (> 60°C). refresh mode, if applicable) as soon as battery temperature is within the specified range. use of refresh mode too frequently may also weaken the battery. [. . . ] This warranty provides the free-of-charge repair or replacement of defective parts only. Parts requiring repair or replacement as a result of normal wear and tear are not covered by this warranty. Additional claims are excluded, unless stringent national rules prohibit such exclusion. In particular, 14 Hilti is not obligated for direct, indirect, incidental or consequential damages, losses or expenses in connection with, or by reason of, the use of, or inability to use the product for any purpose. [. . . ]