User manual HERKULES OFC3

[. . . ] 5 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] · · · · · Operates with external air only. Four oil filter capacity. Page 4 of 8 OWNER/OPERATOR RESPONSIBILITY It is the responsibility of the owner/operator to properly use and maintain this equipment. The instructions and warnings contained in this manual shall be read and understood by the owner/operator prior to operating this equipment. If an owner/operator does not understand English, the contents of this manual shall be explained in the owner/ operator native language to assure the owner/operator comprehends. It is the responsibility of the owner/operator to maintain the legibility of all warning and Instruction labels. The owner/operator shall retain this manual for future reference to Important warnings, operating and maintenance instructions. INSTALLATION Installation consists of anchoring the unit to the floor, connecting an external air supply with 100 to 120 p. s. i. The initial crush of the oil filter(s) will cause the unit to move or jump if not secured properly. relief valve that will bleed off air if the unit is inadvertently connected to an air source greater than 125 p. s. i. Connect the supplied pressure regulator/filter to the crusher 3/8" NPT air inlet fitting. Connect the waste oil drain line to the crusher 1-1/2' NPT waste oil drain fitting. 1/2" Floor Anchor 3/8 NPT Air Inlet Waste oil drain fitting Filter/Regulator Page 5 of 8 INSPECTION Prior to operation a visual Inspection shall be made. Any crusher that appears to be damaged in any way, is badly worn or operates abnormally shall be removed from use until repairs are made. If over pressurizing of the equipment is believed to have occurred, contact a factory authorized service center for inspection of the crusher. An annual inspection by a factory authorized service center is recommended. Verify the pressure gauge on the pressure regulator/filter reads between 100 and 120 p. s. i. NOTE: If the external air supply is less than 100 p. s. i. , the crusher will operate but the crushing performance is reduced. Lift the door latch and pull the door down to gain access to the crushing chamber. Place the oil filter(s) to be crushed gasket side down on the bottom of the crushing chamber. [. . . ] Regularly check the waste oil drain line system to prevent oil backing up in the crusher chamber. Regularly clean the crusher chamber to remove any accumulated oil sludge, metal particles or any other debris that could affect the crusher operation or block the waste oil drain system. Apply grease to door hinges on a regular basis to prevent the door from binding. Apply motor oil to door latch pivot points on a regular basis to prevent latch from binding. [. . . ]