User manual HEIDENHAIN ND 2100G V2.59.0

[. . . ] Relay outputs are two sets of signalling relay contacts that open and close under the control of ND 2100 G formulas. Never use 3-wire to 2-wire adapters or allow the ground connection to the ND 2100 G to be interrupted or disconnected. Caution Changes to the power cable may be made only by an electrical technician. [. . . ] Press the DRO soft key to display the Current Value screen from other screens. Data tables and statistics Press the DATA soft key to show a data table with SPC statistics. Only qualified personnel should be given password access to setup screens. Press the SETUP soft key to display the setup menu on the left side of the LCD screen. Select the language Highlight the desired language and then press the YES soft key. Enter the Supervisor Password Navigate to the SUPERVISOR screen and enter the supervisor PASSWORD. If desired, apply settings from the current channel to all others using the APPLY ALL soft key. Select individual dimensions using the DEC or INC soft keys or apply settings from the current dimension to all others using the APPLY ALL soft key. Default dimension formulas shipped with the ND 2100 G simply show the input encoder channel values as in this example of dimension A, which is given the value of encoder channel C1: A = C1 More complex formulas are created in the FORMULAS setup screen that process one or more encoder input channels to produce sophisticated measurements. In this example, encoder channel C1 is used in max and min functions to produce a runout measurement of a rotating rod: A = max(C1) - min(C1) Navigate to the FORMULAS screen and select the desired DIMENSION using the DEC or INC soft keys. Navigate down to the formula line and enter a formula using the functions displayed on the right side of the screen. Formula functions are changed using the soft keys at the bottom of the screen. Probe surfaces Probe a single point with one encoder channel, or multiple points simultaneously with multiple encoder channels. Enter the measurement data Press the ENTER key when measurements are displayed on the LCD. The report format, type and destination can be changed in setup screens. Note: Advanced formula functions can be used to perform sequential and semiautomated measurements. [. . . ] Elektrisk anslutning Matningsspänning: 100 V~ till 240 V~ (­15 % till +10 %) Matningsfrekvens: 43 Hz till 63 Hz Säkring: T1600 mA, 250 V 5 x 20 mm Two optional remote accessories can be used simultaneously using an RJ-45 splitter. The ND 2100 G is secured to the swivel slots of the mounting stand or arm mount by a shoulder screw, a cap screw mount is shown with associated washers. Använd aldrig adapter för 2-ledare till 3-ledare eller att jordledaren till ND 2100 G är bruten eller urkopplad. [. . . ]