User manual HEARTH AND HOME SFE-35

[. . . ] The information contained in this owner's manual unless noted otherwise, applies to all models. Your new Simplifyre electric fireplace will give you years of durable use and trouble-free enjoyment. Welcome to the Hearth & Home Technologies family of fireplace products! TABLE OF CONTENTS Please read the installation & operation instructions before using this appliance. 7 6 7 Replacement Parts List Warranty 8 9 2 Hearth & Home Technologies Inc. [. . . ] Electrical wiring must comply with local building codes and other applicable regulations to reduce the risk of fire, electrical shock and injury. A dedicated circuit is recommended as other appliances on the circuit may cause the breaker to trip or fuse to blow when the heater is operating. · · · · · · Remove the screws securing the junction block cover. Wire to a properly grounded, 120 volt, 60 Hz, 15 AMP circuit Ensure all junction block connections are tight. Plug in the IEC-320-C14 power plug to the IEC-320-C13 power inlet located on the upper right side of the unit. All components and wiring may be inspected by removing the top inter-panel through the fireplace front opening. B. Locating Your Electric Fireplace Your new electric fireplace may be installed virtually anywhere in your home. However, when choosing a location ensure that the general instructions are followed. Power supply service must be either completed or placed within the heater prior to finishing to avoid reconstruction. Protective cover may stay on during framing, but must be removed before final finishing. Once final finishing has been completed, the protective cover can be used to protect the heater until final installation is complete. C. Do NOT connect the optional low voltage switch and/or thermostat to 120 volt branch circuit. (LEVITON 5634 Series or equal) The Optional Wall Thermostat is a low voltage mechanical type. Framing · · · · Choose a fireplace location and frame as shown in Figure 2. 1. It is important to allow for finished face when setting the depth of the frame. If a hearth system or raised hearth is to be installed, the unit MUST be raised to provide service access and use of optional fronts. Level it with shims if necessary, and attach the unit to the frame using the nailing flanges provided. H. Finishing Combustible or non-combustible materials may be used to finish up to the fireplace opening. Note: ensure that you leave adequate room to remove and replace the front screen or optional front. · · E. · SFE-35 · 4050-313 Rev C · 01/08 2 Fireplace Dimensions 22 in. 77. 5 cm Note: Nailing flanges may be hand-bent to accommodate framing for different styles of optional decorative fronts. 86. 4 cm Rough Opening Height Note: The bottom surface of this fireplace must be elevated to the level of the finished surface in front of the fireplace to allow access for service and the use of optional fronts. Figure 2. 1 Fireplace Specifications and Framing Dimensions 5 Hearth & Home Technologies Inc. [. . . ] The owner/user assumes all other risks, if any, including the risk of any direct, indirect or consequential loss or damage arising out of the use of or inability to use the product. The warranty will not apply if, in the sole judgement of the Company, damage or failure has resulted from accident, alteration, misuse, abuse, incorrect installation, or operation on an incorrect power source. The foregoing is in lieu of all other warranties expressed, implied, or statutory, and the Company neither assumes, nor authorizes any person to assume for it any other obligation, or liability in connection with said product. *Light bulbs are not covered in the warranty. How to Obtain Service. To obtain service under this warranty you must: 1. [. . . ]