User manual HAUPPAUGE WINTV-PVR-USB2 MCE

[. . . ] WinTV-PVR-USB2 MCE Personal Video Recorder Quick Installation Guide for Windows XP Media Center Edition 2005 © Hauppauge Computer Works, Inc. 91 Cabot Court Hauppauge, NY 11788 Telephone: 631-434-1600 Fax: 631-434-3198 Tech Support: 631-434-3197 techsupport@hauppauge. com Telephone: 02161-694880 Fax: 02161-6948815 Tech Support: 02161-6948840 info@hauppauge. de Telephone: 0207-378-1997 Fax: 0207-357-9171 Tech Support: 0207-378-0202 support@hauppauge. co. uk Hauppauge Computer Works, GmbH Krefelder Straße 669 41061 Mönchengladbach, Germany Hauppauge Computer Works, Ltd 6-10 Bank Chambers Borough High Street London, U. K. [. . . ] This may not be necessary if your TV aerial or cable network supplies FM, or if you do not want to listen to radio with Media Center. The S-Video and Composite video inputs and the Left & Right Audio Inputs can be used to bring audio/video from a VCR, camcorder, DVD player or satellite receiver. Plug one end (the square end) of the supplied USB cable in the WinTVPVR-USB2's USB Cable connector. FM radio antenna connector Left &Right Audio Inputs Composite video input S-Video input TV Connector for antenna or Cable TV USB Cable Connector Power Supply input 2 Step 2: Boot your PC. Step 3: Plug the power supply into WinTV-PVR-USB2 Plug the supplied Power Supply into the Power Supply input on WinTV-PVRUSB2. N ote: DO NOT PLUG THE POWER INTO WINTV-PVR-USB2 UNTIL YOUR PC HAS COMPLETELY BOOTED! Step 4: Installing the WinTV-PVR-USB2 MCE driver After plugging the power to your WinTV-PVR-USB2, the Found New Hardware Wizard will appear. Insert the WinTV-PVR MCE Driver Installation CD-ROM in your PC's CD-ROM drive and make sure Install the software automatically (Recommended) is checked. Click Finish. Removing the WinTV-PVR driver If you ever need to remove the WinTV driver, run HCWClear. EXE from the WinTV-PVR MCE Installation CD-ROM. WinTV-PVR-USB2 setup under Media Center Edition 2005 If you are using the WinTV-PVR under Windows XP Media Center Edition 2005, you should run the TV Setup Wizard in Media Center. Normally, the next time you run Media Center after the installation of a new TV tuner, the Setup Wizard will run. This might not happen if you had previously installed a different TV tuner board or USB device. To manually launch the TV Set Up Wizard, in the main Media Center menu go to Settings / TV / Set up TV Signal. You will then see Chose your Region, select your region and click Next. If you are using WinTV-PVR-USB2 for receiving analog TV, you will see the message Select cable, satellite, Antenna or no signal at this time. Click Next. N ote: at this point, Media Center Edition will set up the TV tuner. This might take a minute or so. 3 After Media Center returns with the You're Done!message, your WinTV-PVR will have been set up by Media Center Edition. [. . . ] Click the button Enable access to this program for Media Center Radio. When the box is selected, Radio will appear on the Media Center Start menu; when the box is cleared, Radio will not appear. QI-MCE-V3. 2-ENG 4 June. [. . . ]