User manual HAUPPAUGE WINTV-PVR-500 MCE KIT

[. . . ] WinTV-PVR for Media Center Edition Quick Installation Guide WinTV-PVR-150 MCE Kit WinTV-PVR-500 MCE Kit © Hauppauge Computer Works, Inc. 91 Cabot Court Hauppauge, NY 11788 Hauppauge Computer Works, GmbH Krefelder Straße 669 41061 Mönchengladbach, Germany Hauppauge Computer Works, Ltd 6-10 Bank Chambers Borough High Street London, U. K. SE1 9QQ Telephone: 631-434-1600 Tech Support: 631-434-3197 techsupport@hauppauge. com Telephone: 02161-694880 Tech Support: 02161-6948840 info@hauppauge. de Telephone: 0207-378-1997 Fax: 0207-357-9171 Tech Support: 0207-378-0202 support@hauppauge. co. uk www. hauppauge. com Included with the WinTV-PVR-150/500 MCE Kits: · WinTV-PVR-150 MCE PCI board, with 125 channel cable ready TV tuner, MPEG-2 hardware audio/video compressor. [. . . ] Audio input from an external A/V device can be brought into the WinTV-PVR-150 WinTV-PVR-150 WinTV-PVR-500 Board connectors FM Radio Connector input (WinTV-PVR-500 only) TV Connector for antenna or Cable TV input S-Video input Composite video input connector Left audio input Right audio input 2 /500MCE via the white and red audio input jacks. Step 2: Installing the WinTV-PVR-150/500 Media Center driver After installing the WinTV-PVR in your PC, boot Windows. Insert the WinTV-PVR MCE Driver Installation CD-ROM in your PC's CD-ROM drive. Make sure Install the software automatically (Recommended) is checked. If you are installing the dual tuner WinTV-PVR-500MCE, you will see the Found New Hardware message for the second TV tuner. Install the Media Center Remote control The Media Center remote control receiver is a USB device which both receives remote control commands and also transmits commands via an IR Blaster to a set top box to change channels. To install the Media Center remote control, simply plug it into any USB port. To test the Media Center remote, click the Start button in the middle of the remote control. If you have a satellite set top box and would like the Media Center remote control receiver to change channels, plug one end of the IR Blaster cable into the Media Center remote control receiver and position the other end (the transmitter end) over the IR receiver on your set top box. TV set up under Media Center Edition To manually launch Media Centers TV Set Up Wizard, in the main Media Center menu go to Settings / TV / Set up TV Signal. Click Next. N ote: at this point, Media Center Edition will set up the TV tuner. This might take a minute or so. You will then see a message saying Examining your TV signal. When it is finished, it will tell you whether you have a cable TV, antenna or set top box connection. 3 After determining the type of signal, Media Center displays a message You are Done!The Program Guide Set Up Wizard will move you through the completion of the Program Guide set up. When you are finished with the Program Guide Setup, you can start watching TV under Media Center! [. . . ] Under Choose a default media player, select the check box next to Media Center Radio. Click the button Enable access to this program for Media Center Radio. When the box is selected, Radio will appear on the Media Center Start menu; Radio will not appear if unchecked. 4 [. . . ]