User manual HAUPPAUGE WINTV-NOVA-T MCE

[. . . ] The WinTV-PVR-500MCE comes with dual TV tuners and dual hardware MPEG encoders plus one FM radio receiver. WinTV-NOVA-T MCE is a terrestrial DVB-T receiver PCI Board, which receives digital DVB-T television. WinTVHVR-1100 and WinTV-HVR-1300 are hybrid analog + digital TV receiver boards for PAL TV and DVB-T. [. . . ] S-Video input Composite video input (yellow) Audio Left input (white) Audio Right input (red) 2 WinTV-NOVA-T MCE connectors TV Connector for DVB-T antenna Loop Back Connector for Antenna OUT 2. 5mm IR Jack for Hauppauge remote control receiver (not used for Media Center) Audio and video from an external A/V device (satellite TV receiver, cable TV box, VCR, camcorder, camera, DVD player) can be brought into the WinTV-PVR via the back panel connectors. If your A/V device uses S-Video, connect to the S-Video input on the WinTV-PVR-150/500MCE. If your video device uses composite video instead of S-Video, use the yellow RCA jack. Audio input from an external A/V device can be brought into the WinTV-PVR150/500MVCE via the white and red audio input jacks. Step 2: Installing the WinTV-PVR-150/500/NOVA-t MCE driver After installing the WinTV-PVR or WinTV-NOVA-t in your PC, boot Windows. Insert the WinTV MCE Installation CD-ROM in your PC's CD-ROM drive and make sure Install the software automatically (Recommended) is checked. If you are installing the dual tuner WinTVPVR-500MCE, you will see the Found New Hardware message for the second TV tuner. Step 3: For WinTV-HVR-1100, install the software MPEG encoder for Media Center. Run WinTV-HVR-1100_Setup. EXE from the from the WinTV MCE Installation CD-ROM. Set up TV under Media Center Edition If you are using the WinTV-PVR or WinTV-NOVA under Windows XP Media Center Edition, you should run the TV Setup Wizard in Media Center. To manually launch the TV Set Up Wizard, in the main Media Center menu go to Settings / TV / Set up TV Signal. Next you'll see Select your TV signal (Cable, Satellite, Antenna). If you chose Antenna, you will see a menu which asks: Select Your Signal Type. If you are using the WinTV-NOVA or WinTV-HVR to receive digital terrestrial TV, select Digital Terrestrial (DVB-T). After Media Center downloads and sets up the Guide, if you want to receive DVB-T digital TV and are using WinTV-NOVA or the WinTV-HVR boards, you will see the Start Scan Wizard. [. . . ] However, if the Radio button still does not appear on the Start menu, you may need to turn on Radio in Set Program Access and Defaults (see below). Click the Start button on the taskbar, point to All Programs, and then click Set Program Access and Defaults. Under Choose a default media player, select the check box next to Media Center Radio. [. . . ]