User manual HAUPPAUGE WINTV HVR-1850 QUICK START GUIDE

[. . . ] Configuring the WinTV-HVR-1850 and WinTV-HVR2250 built-in IR blaster for use with WinTV v7 The IR Configuration Utility is used to configure the WinTV-HVR-2250 and WinTVHVR-1850's built-in remote control IR blaster for use with either WinTV v7 or Windows Media Center. 2. [. . . ] Run BlasterCfg. EXE First make sure the IR transmitter is positioned over the remote sensor on your set top box. Remember, the IR transmitter has a very short transmission distance and needs to be positioned over the remote sensor on your set top box. You will need to `learn' the 0 through 9 keys, plus Power on and Enter. To learn the new keys: To run the IR configuration utility, go to the WinTV program group and click on HCWCIRConfig_Tool. exe (this file can also be found on the WinTV V7 installation CD in the MISC folder). To configure the IR blaster for use with WinTV v7, remove the check from the box labeled Hauppauge WinTV. To configure as a Windows Media Center remote control, put a check in the box labeled Hauppauge Consumer Infrared Receiver Click OK to save the changes. hold the remote control from your set top box as close to the IR receiver and learn sensor as possible - N N N ote: your computer must be restarted for the changes to take effect. - Learning remote control codes for your set top box In WinTV v7, the IR RemoteBlaster lets the WinTV-HVR board change the channel on a satellite or cable TV set top box by transmitting `channel change' commands to the box via an Infra Red (IR) transmitter. in the Blaster config program, click the button you would like to learn (for example: 1) then depress and hold the corresponding key on your set top box remote control. You will be instructed in the message box when to release the key onyour remote control. Do this for the keys 0 to 9 plus On Send button and Enter You should receive a LearnKey(key#) Succeeded message. [. . . ] The IR cable jack plugs into the back of the WinTV board, and the IR transmitter needs to be positioned over the IR receiver on your set top box using the self stick tape supplied on the front of the transmitter. ConfigIR_v1 09/24/09 [. . . ]