User manual HATCO WFSTM-0297

[. . . ] FLAV-R-SAVOR WFST Series Installation & Operating Manual I & W #07. 04. 248. 00 ® Large Capacity Merchandising Cabinets This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you are unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] The signs are designed to be installed on three (3) sides of the cabinet above the glass panels. Merchandising decal signs are red and yellow reading "Today's Hot Specials" and are reusable when utilizing a dry-erase marker. Before installing decals, clean the aluminum side panels with a non-oily cleaner, such as isopropyl alcohol (rubbing alcohol). After the cleaned surfaces have dried, simply remove the protective backing from the sign or decal and apply to the panel. Any air pockets or bubbles behind the sticker can be removed by rubbing gently with a soft cloth from the center towards the outer edges. HATCO FLAV-R-SAVOR Figure 10. WFSTM-0297 FOOD HOLDING GUIDE Type of Food Bagels Biscuits Chicken - Parts Chicken - Whole Croissants Fish Frankfurters Fruit Pies Hot Dogs (Appetizers) Onion Rings Pizza Pretzels Ribs Wrapped Sandwiches Maximum Humidity Holding Time Setting 3 Hours Low 2 Hours Medium 5 Hours High 2 Hours High 3 Hours Low 1 Hour Medium 2 Hours High 3. 5 Hours Medium 4 Hours High 1 Hour Low 1 Hour Medium 3 Hours Medium 2 Hours High 2 Hours 4 Temperature Setting °F 4 140 3 130 5 175 5. 5 180 4 140 5. 5 180 6 185 4 140 5 175 4 140 6 185 4 140 6 160 5. 5 180 °C 60 54 79 82 60 82 85 60 79 60 85 60 85 82 NOTE: All times and settings are recommendations only and may vary depending on product preparation, cooking time and internal food temperature. OPERATION 1. Plug the cabinet into an electrical outlet of the correct voltage, size and plug configuration. Turn the power switch on the control panel to "ON. " The indicator lights will light up at this time. Slowly pour the water into the cup until the red light for low water indication goes off. Use of softened or distilled water is recommended to preserve the life of the electrical and mechanical components in the reservoir. If "hard" water is used, the reservoir will require periodic cleaning and deliming. (See MAINTENANCE for deliming instructions. ) NOTE: On the initial fill the water reservoir capacity is 90 ounces (2661 ml) or 3/4 of a gallon. Set the temperature selector to the desired temperature. * *See the FOOD HOLDING GUIDE for recommendations. Figure 11. Flav-R-Savor Large Capacity Control Panel. Allow 30 minutes to preheat a full reservoir of water. The green humidity cycle indicator lamp will go out when the interior of the cabinet has reached the selected humidity setting. The Flav-R-Savor Large Capacity is then ready to hold foods at the humidity and temperature selected. NOTE: Temperature and humidity settings may vary depending upon product make-up and consistency. The cabinet temperature indicator displays the lowest temperature point inside the cabinet, not the product temperature. 7 Form No. WFSTM-0297 OPERATION The reservoir capacity permits uninterrupted operation for approximately 3 to 6 hours, depending on the settings and how frequently the door is opened. When the red low water indicator lamp is lit, add water to the reservoir. The water reservoir refill capacity is approximately 48 ounces (1420 ml), or three (3) pints. Units with the Auto-Fill option are filled automatically when the red low water indicator lamp comes on. CLEANING WARNING: To prevent electric shock, always unplug the Flav-RSavor Large Capacity Holding and Display Cabinet before any cleaning or maintenance. [. . . ] Hatco reserves the right to accept or reject any such claim in whole or in part. Hatco will not accept the return of any Product without prior written approval from Hatco, and all such approved returns shall be made at Buyer's sole expense. HATCO WILL NOT BE LIABLE, UNDER ANY CIRCUMSTANCES, FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, INCLUDING BUT NOT LIMITED TO LABOR COSTS OR LOST PROFITS RESULTING FROM THE USE OF OR INABILITY TO USE THE PRODUCTS OR FROM THE PRODUCTS BEING INCORPORATED IN OR BECOMING A COMPONENT OF ANY OTHER PRODUCT OR GOODS. 10 Form No. WFSTM-0297 HATCO AUTHORIZED PARTS DISTRIBUTORS ALABAMA Jones McLeod Appl. [. . . ]