User manual HATCO TQ2M-1005(1)

[. . . ] Toast Qwik® Electric Conveyor Toasters TQ-10, TQ-15, TQ-400, TQ-800, TQ-1200, TQ-1800 Series Installation & Operating Manual I&W #07. 05. 124. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you're unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] If safe distances are not maintained, discoloration or combustion could occur. Do not locate toaster under shelving or closer than 12" (305 mm) from the ceiling. WARNING To assure safe and proper operation while operating in the Front Discharge mode, allow a minimum clearance of 1" (25 mm) along the sides and rear. WARNING To assure safe and proper operation while operating in the Rear Discharge mode, allow a minimum clearance of 1" (25 mm) along the sides. Allow a minimum clearance of 12" (305 mm) along the front and rear. LENGTHEN Figure 5. Adjustable Legs (TQ-10 & TQ-15 Models Only) CAUTION To avoid any injury or damage locate the unit at the proper counter height, in an area that is convenient for use. The location should be level to prevent the unit or its contents from accidentally falling, and strong enough to support the weight of the unit and food. CAUTION Do not place anything on top of the toaster; doing so could damage toaster or subject personnel to possible injury. Form No. TQ2M-1005 8 INSTALLATION SET-UP CAUTION Unit is not weatherproof. For safe and proper operation the unit must be located indoors where the ambient air temperature is a minimum of 70°F (21°C) and a maximum of 85°F (29°C). CAUTION The toasting of coated or buttered products such as garlic bread, cheese sandwiches and sweet rolls is NOT recommended. Residue will reduce toaster performance and could possibly ignite inside the toaster. CAUTION When setting up the unit for operation, make sure power to the unit is off and the toaster is at room temperature. Toast Feed Ramp TOAST FEED RAMP The toast feed ramp is installed at the factory and can be used in two positions. Bread products enter the toaster by placing them on the feed ramp and releasing. For manual feeding of product, tip the feed ramp until it rests on top of the unit. In this position bread products can be manually loaded by placing directly on the conveyor belt. Use caution when touching these areas to avoid injury. Toast Crumb Tray Figure 7. Toast Crumb Tray Stop Pins TOAST CRUMB TRAY Install toast crumb tray directly below the conveyor belt and below the stop pins. CAUTION To avoid damage to the unit or injury to personnel always operate toaster with crumb tray installed. CAUTION To avoid any injury, do not remove the crumb tray for cleaning until toaster is cool. 9 Form No. TQ2M-1005 INSTALLATION FRONT OR REAR DISCHARGE Toast-Qwik® units can be set up so toasted product discharges at either the front or the rear of the unit. [. . . ] HATCO WILL NOT BE LIABLE, UNDER ANY CIRCUMSTANCES, FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, INCLUDING BUT NOT LIMITED TO LABOR COSTS OR LOST PROFITS RESULTING FROM THE USE OF OR INABILITY TO USE THE PRODUCTS OR FROM THE PRODUCTS BEING INCORPORATED IN OR BECOMING A COMPONENT OF ANY OTHER PRODUCT OR GOODS. Form No. TQ2M-1005 HATCO AUTHORIZED PARTS DISTRIBUTORS ALABAMA Jones McLeod Appl. Phoenix 602-252-0402 CALIFORNIA Industrial Electric Huntington Beach 714-379-7100 INDIANA GCS Service Indianapolis IOWA Electric Motor Service Co. Davenport 319-323-1823 Goodwin Tucker Group Des Moines 515-262-9308 KENTUCKY GCS Service Louisville LOUISIANA Chandlers Parts & Service Baton Rouge 225-272-6620 MARYLAND Electric Motor Service Baltimore 410-467-8080 GCS Service Silver Spring MASSACHUSETTS Ace Service Co. , Inc. [. . . ]