User manual HATCO TFC461RM-1104(1)

[. . . ] THERMO-FINISHERTM Conveyor Food Finisher TFC-461R Series Installation & Operating Manual I & W #07. 05. 149. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you are unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] After 3 seconds, the upper heat indicator glows and the unit displays (Upper Power Value). The lower heat indicator glows and the display reads (Lower Power Value). The display shows (the time value for how long conveyor remains stopped). 10. Press the program button selected in Step 1 to save all the settings into memory. NOTE: In the Continuous Run mode, the conveyor advances in 1/2 second increments. IDLE MODE When the unit reaches mode, the upper heating elements automatically go into a programmed idle power setting. (The display will still show during idle mode. ) The unit remains in IDLE mode until one of the ten Program buttons are pressed, or the unit goes into AUTO-OFF Mode. NOTE: Begin with an IDLE mode setting of 30% and adjust the program accordingly to achieve optimum performance. Simultaneously press/hold the UP arrow key and the ENTER button for three seconds. TFC461RM-1104 8 PROGRAMMING CONTROLLER AUTO-OFF MODE The AUTO-OFF mode turns all the elements off if the unit has not been used for a programmed length of time. This feature can be adjusted from 1­60 minutes in one minute increments, or it can be set to never shut off by itself. With display showing , simultaneously press/hold the DOWN arrow key and ENTER button for three seconds. The time value can be set from 0 (never shuts off) to 60 minutes, in single minute increments. Press the ENTER button to save setting. CONVEYOR STOP ADJUSTMENT When operating the unit using control buttons one through eight the unit will cycle once, conveying the product into the heating area pausing to heat the food at the pre-set time/temperature, and then conveying the product out the left side of the unit and stopping. NOTE: If food product does not stop in the center of the heating area please adjust using the following steps: 1. With display showing , press the UP and DOWN buttons simultaneously for three seconds. If the food product is transported too far into the heating area, adjust by pressing the DOWN button. If food product is not transported far enough, adjust by pressing the UP button. Each time the UP or DOWN button is pressed the valve will change by 0. 1 of a second. button to save the new SELECTING AN ADDITIONAL PROGRAM Once food product is transported into the heating area one additional program can be selected in advance. After the selection is made the program lamp will blink indicating the next program. PROGRAMMING HINTS: · On menu items in which internal temperatures are critical (such as chicken or pork), the primary heat source comes from the bottom. On menu items in which the surface temperatures are critical (such as cheese melting), the primary heat source comes from the top. · When performing product testing, use three food pan/plates with the same product and run through the unit in succession. [. . . ] Hatco reserves the right to accept or reject any such claim in whole or in part. Hatco will not accept the return of any Product without prior written approval from Hatco, and all such approved returns shall be made at Buyer's sole expense. HATCO WILL NOT BE LIABLE, UNDER ANY CIRCUMSTANCES, FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, INCLUDING BUT NOT LIMITED TO LABOR COSTS OR LOST PROFITS RESULTING FROM THE USE OF OR INABILITY TO USE THE PRODUCTS OR FROM THE PRODUCTS BEING INCORPORATED IN OR BECOMING A COMPONENT OF ANY OTHER PRODUCT OR GOODS. Form No. TFC461RM-1104 HATCO AUTHORIZED PARTS DISTRIBUTORS ALABAMA Jones McLeod Appl. [. . . ]