User manual HATCO TF2OM-0603

[. . . ] THERMO-FINISHERTM Food Finisher TF 2000 Series Installation & Operating Manual I & W #07. 05. 110. 00 1 2 3 4 5 OFF POWER ON This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you're unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] Lower Power Value (LP): Press the ENTER button and the unit will display P XX (Figure 7F). Lower Time Value (LT): Press the Enter button and the unit will display T XX (Figure 7G). Press the Program Selection button to enter all the settings into memory. NOTE: If no adjustments are made within 15 seconds, the controller will revert back to the normal mode and will not accept any changes. Also, pressing any of the numbered Program buttons after this 15 second interval will take the unit out of the programming mode without accepting any changes. If ready to finish food, place product in unit to the back wall and press desired Program Selection button. Using a grease pencil or "China" pencil, record the specific food entree on the control panel next to the selected Program button. NOTE: All units keep the power and timing settings in memory, even when the unit is turned off or is unplugged from the power source. NOTE: Models TF-2005, TF-2010 and TF-2045 do not have lower heating elements but all steps must be performed as if a bottom heating element is present. The power (LP) and time (LT) values set for the bottom zone must be less than the top zone for proper operation. Form No. TF20M-0603 8 PROGRAMMING CONTROLLER 7A 7B 7C 7D 7E 7F 7G Figure 7. TF20M-0603 PROGRAMMING CONTROLLER IDLE MODE The Thermo-FinisherTM features an "Idle" mode. Once the unit reaches the rEdY mode, the upper heating element(s) automatically go into a programmed idle power setting. The unit will stay in this mode until one of the five Program buttons is pressed, or the unit goes into auto-shut off. NOTE: Begin by setting the idle mode power setting at 20% and adjust the program accordingly to achieve optimum performance. Press and hold the UP arrow while, at the same time, press and hold the ENTER button for three seconds. To adjust the idle mode, press either the UP or DOWN arrow until you reach the desired setting (Figure 8B). To accept the new value, push the ENTER button a second time (Figure 8C). NOTE: If no adjustments are made within 15 seconds, the controller goes back to its original settings without accepting the change. Pushing any of the numbered program buttons will also take the controller out of programming mode without accepting the change. To adjust the Auto-Off time push either the UP or DOWN arrow until you reach the desired setting (Figure 9B). The Auto-Off mode can be adjusted from "0" (indicating unit will not turn off) to 60 minutes until turn off time, in single minute increments. [. . . ] Hatco will not accept the return of any Product without prior written approval from Hatco, and all such approved returns shall be made at Buyer's sole expense. HATCO WILL NOT BE LIABLE, UNDER ANY CIRCUMSTANCES, FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, INCLUDING BUT NOT LIMITED TO LABOR COSTS OR LOST PROFITS RESULTING FROM THE USE OF OR INABILITY TO USE THE PRODUCTS OR FROM THE PRODUCTS BEING INCORPORATED IN OR BECOMING A COMPONENT OF ANY OTHER PRODUCT OR GOODS. 16 Form No. TF20M-0603 HATCO AUTHORIZED PARTS DISTRIBUTORS ALABAMA Jones McLeod Appl. Phoenix 602-252-0402 CALIFORNIA Industrial Electric Huntington Beach 714-379-7100 IOWA Electric Motor Service Co. [. . . ]