User manual HATCO PMGH-60M-0405(1)

[. . . ] · Ne touchez à aucun interrupteur; ne pas vous servir des téléphones se trouvant dans le bâtiment. · Appelez immediatement votre fournisseur de gaz depuis un voisin. · Si vous ne pouvez rejoindre le fournisseur, appelez le service des incendies. · L'installation et l'entretien doivent être assurés par un installateur ou un service d'entretien qualifié ou par le fournisseur de gaz. CONTENTS Important Owner Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . i Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . i Model Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 All Models . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Electric . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Wiring Diagram. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Hatco Limited Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Authorized Parts Distributors . . . . . . . . . . . . . . . . . . . . . Back Cover IMPORTANT OWNER INFORMATION Record the model number, serial number (identification plate located on the lower right hand side, front corner of the unit), voltage and purchase date of your PMGH-60 Accessory Flue Hood in the spaces below. [. . . ] 24-3/8" wide, 15-1/2" deep, 6-7/8" high (619 x 394 x 175 mm). 10 pounds (5 kg). DIMENSIONS 4-5/8" (118 mm) 7/8" KO HOLE 4" (102 mm) 4" (102 MM) DIA. FLUE ADAPTOR 13-1/4" (337 mm) 6-7/8" (175 mm) 24-3/8" (619 mm) Figure 2. PMGH-60M-0405 2 INSTALLATION GENERAL Code Requirements Installation must be in accordance with local codes, or in the absence of local codes, with the latest edition of the National Fuel Gas Code, ANSI Z223. 1, (a portion of the 1996 code relating to ventilation is excerpted in Figure 3) the National Electrical Code, ANSI/NFPA 70. Canadian installations should conform with CSA-B149. 1, Natural Gas and Propane Installation Code, and CSA-C22. 1, Electrical code, and/or local installation codes. {Les installations canadiennes doivent se conformer aux CODES D'INSTALLATION CSA-B149. 1, Natural Gas and Propane Installation Code, et CSA-C22. 1, Electrical Code, et/ou aux codes locaux d'installation. } 1. Place the unit (with the 4" [102 mm] diameter flue adapter facing toward the rear) directly on top of the Hatco PMG-60 Gas Booster Heater, nesting the assembly with the brackets inside of the Auxiliary Hood. Connect 4" (102 mm) diameter flue pipe to the adapter to direct the flue gas up to 20 linear feet (6 meters) away from the unit. Terminate the flue pipe at a location that will not become obstructed, so that it will not exhaust directly toward any combustibles. WARNING The flow of air to the heater for combustion and ventilation must not be obstructed. This unit is designed to vent directly into the room and is intended for commercial food service water heating only. WARNING Flue gases exit top sides of this unit and must not be obstructed, specified clearances must be maintained for safe operation. EXCERPT FROM ANSIZ223. 1/NFPA #54 7. 2. 1 Connection To Venting Systems. Excerpt as permitted in 7. 2. 2 through 7. 2. 6, all gas utilization equipment shall be connected to venting systems. A single booster-type [automatic instantaneous] water heater, when designed and used solely for the sanitizing rinse requirements of a dishwashing machine, provided that the equipment is installed, with the draft hood in place and unaltered, if a draft hood is required in a commercial kitchen having a mechanical exhaust system. Where installed in this manner, the draft hood shall not be less than 36 inches (914 mm) vertically and 6 inches (152 mm) horizontally from any surface other than the equipment. Where any or all of this equipment is installed so the aggregate input rating exceeds 20 Btu per hour per cubic foot (207 watts per m3) of room space in which it is installed, one or more shall be provided with venting systems or other approved means for removing the vent gases to the outside atmosphere so the aggregate input rating of the remaining unvented equipment does not exceed the 20 Btu per hour per cubic foot (207 watts per m3) figure. Where the room or space in which the equipment is installed is directly connected to another room or space by a doorway, archway or other opening of comparable size that cannot be closed, the volume of adjacent room or space shall be permitted to be included in the calculation. National Fuel Gas Code COMPONENTS The Hatco Gas Booster Heater Exhaust Hood operates on 120 VAC, 60 Hz, 15 amp, single phase service. WARNING If an external electrical source is utilized, the appliance, when installed, must be electrically grounded in accordance with local codes, or, in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, CSA C22. 1, Electrical Code. ELECTRICAL CONNECTIONS To connect the field wiring to the booster hood: 1. PMGH-60M-0405 MAINTENANCE GENERAL Inspect the fan monthly to make sure it is operating freely and is free of lint and dirt. WARNING Always disconnect the power and shut off gas supply prior to performing any maintenance on the booster heater to avoid possible personal injury or damage to the booster heater. SWITCH 02. 19. 080. 00 WARNING Label all wires prior to disconnection when servicing controls. WARNING If service is required on this unit, contact your Authorized Hatco Service Agent, or contact the Hatco Service Department at 800-558-0607 or 414-671-6350; fax 800-690-2966 or International fax 414-671-3976. [. . . ] San Francisco COLORADO Hawkins Commercial Appliance Englewood 303-781-5548 DELAWARE Food Equipment Service Wilmington 302-996-9363 FLORIDA Whaley Foodservice Repair Jacksonville 904-725-7800 Universal Restaurant Services Miami 305-593-5488 Nass Service Co. , Inc. Pompano Beach 954-971-0456 650-635-1900 CANADA 405-528-8883 BRITISH COLUMBIA Key Food Equipment Service Vancouver 604-433-4484 MANITOBA Denko Mechanical Ltd. Toronto Choquette CKS Ottawa QUÉBEC Choquette CKS Montreal Choquette CKS Québec City 514-722-2000 418-681-3944 416-422-5580 613-739-8458 Comm. Appliance Service Tampa 813-663-0313 GEORGIA TWC Services Smyrna Heritage Service Group Norcross 866-388-9837 Southeastern Rest. [. . . ]