User manual HATCO HLM-0299

[. . . ] Your Hatco Display Light is a product of extensive research and field testing. The materials used were selected for maximum durability, attractive appearance and optimum performance. Every unit is thoroughly inspected and tested prior to shipment. Printed February 1999 i Form No. HLM-0299 IMPORTANT SAFETY INSTRUCTIONS ! WARNINGS/CAUTIONS Read the following important safety instructions to avoid personal injury and/or damage to the equipment. [. . . ] To prevent delay in obtaining warranty coverage, fill out and mail in warranty card. The unit is equipped with mounting brackets as shown in Figure 3 for chain mounting or mounting under a shelf or pass-through station. WARNING Chain must be sufficient strength and securely fastened or the lamp could come loose, possibly causing personal injury or damage to the unit. Standard Bracket Mounting with Chains ELECTRICAL WIRING HOOK-UP Hatco provides a 1/2" (12 mm) trade size knockout opposite the on/off switch, 6" (15 cm) long pigtail wire leads and a separate grounding terminal in the wiring compartment. For correct installation, provide supply wires rated for at least 90° C (194° F) from a properly sized fused disconnect or circuit breaker conforming to local electrical codes. Use UL recognized wire nuts rated for at least 90° C (194° F) and properly sized for connection. Consult a local licensed electrical contractor if you have any questions on proper installation. Refer to the Electrical Rating Chart for specific information. Figure 4. Adjustable Bracket Mounting OPERATION Turn the toggle switch to the ON position. Printed February 1999 3 Form No. HLM-0299 MAINTENANCE CLEANING The Hatco Display Light is designed for maximum durability and performance, with minimum maintenance. WARNING To avoid any injury, turn the power switch off, unplug the unit from the power source and allow to cool before performing any maintenance. To preserve the finish of the Hatco Display Light, it is recommended that the surfaces be wiped daily with a damp cloth. Abrasive cleaners could scratch the finish of your Glo-Rite Display Light, marring its appearance and making susceptible to dirt accumulation. DISPLAY LIGHT BULB REPLACEMENT The display light is a shatter-resistant, incandescent light bulb which illuminates the area. The bulb has a special coating to guard against injury and food contamination in the event of breakage. To replace a light bulb, disconnect the power supply and wait until the unit has cooled. Unscrew the light bulb from the unit and replace it with a new specially coated incandescent bulb. Breakage of light bulbs not specially coated could result in personal injury and/or food contamination. Figure 5. PRODUCT WARRANTY Hatco warrants the products that it manufactures (the "Products") to be free from defects in materials and workmanship, under normal use and service, for a period of one (1) year from the date of purchase when installed and maintained in accordance with Hatco's written instructions. Buyer must establish the product's purchase date by returning Hatco's Warranty Registration Card or by other means satisfactory to Hatco in its sole discretion. Hatco warrants the following Product components to be free from defects in materials and workmanship from the date of purchase (subject to the foregoing conditions) for the period(s) of time and on the conditions listed below: a) One (1) Year Parts and Labor PLUS One (1) Additional Year Parts-Only Warranty: Toaster Elements (metal sheathed) Drawer Warmer Elements (metal sheathed) Drawer Warmer Drawer Rollers and Slides Food Warmer Elements (metal sheathed) Display Warmer Elements (metal sheathed air heating) Holding Cabinet Elements (metal sheathed air heating) Cook and Hold Oven Elements (metal sheathed) b) One (1) Year Parts and Labor PLUS Four (4) Additional Years Parts-Only Warranty on pro-rated terms that Hatco will explain at Buyer's Request: Powermite Gas Booster Heater Tanks Mini Compact Tanks (stainless steel) 3CS and FR Tanks c) One (1) Year Parts and Labor PLUS Four (4) Additional Years Parts-Only Warranty PLUS Five (5) Year Parts-Only Warranty on prorated terms that Hatco will explain at Buyer's Request: Booster Heater Tanks (Castone) d) One (1) Year Parts-Only Warranty for components not installed by Hatco: Accessory Components (including but not limited to valves, gauges and remote switches) THE FOREGOING WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTY, EXPRESSED OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE OR PATENT OR OTHER INTELLECTUAL PROPERTY RIGHT INFRINGEMENT. [. . . ] Columbia 803-791-4420 TENNESSEE Camp Electric Memphis 901-527-7543 973-575-9145 973-691-6300 NEW YORK Acme American Repairs, Inc. Brooklyn 718-386-2515 Appliance Installation Buffalo 716-884-7425 Northern Parts Dist. Syracuse 315-422-9271 NORTH CAROLINA Authorized Appliance Charlotte 704-377-4501 OHIO Akron/Canton Comm. Akron 330-753-6635 Certified Service Center Cincinnati 513-772-6600 GCS Service Columbus 614-476-3225 TEXAS City Kitchen Service Co. [. . . ]