User manual HATCO GRSDM-0903

[. . . ] GLO-RAY ® Merchandising Display Warmer GRSDH, GRSDS & GRSDS/H Series Installation & Operating Manual I&W #07. 05. 011. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you're unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] Care should be taken when unpacking shipping carton to avoid damage to unit and components enclosed. WARNING To prevent any injury or damage to the unit do not pull unit by power cord. WARNING To prevent any injury, discontinue use if power cord is frayed or worn. To prevent delay in obtaining warranty coverage, fill out and mail in the warranty card. CAUTION The National Sanitation Foundation (NSF) requires units over 36" (914 mm) in length or weighing more than 80 lbs. If this unit cannot be sealed at the point of use, 4" (102 mm) legs are included to allow for proper cleaning access below unit. WARNING Do not lay unit on the side with the control panel or damage to unit could occur. Carefully lay unit on its side and install the four legs as shown in Figure 5. Slide each side glass panel into the upper channel, then lower the panel into the lower channel. To install them, place the bars in the channels provided (see Figure 7). The bars can be readily adjusted to separate your holding areas as needed. Figure 7. Leg Installation are susceptible to active air movements or currents should be avoided, i. e. , near exhaust fans or hoods and air conditioning ducts. WARNING For safe and proper operation, the unit must be located a reasonable distance from combustible walls and materials. If safe distances are not maintained, discoloration or combustion could occur. CAUTION To avoid any injury or damage locate the unit at the proper counter height, in an area that is convenient for use. The location should be level to prevent the unit or its contents from accidentally falling, and strong enough to support the weight of the unit and food displayed. LOCATION NOTE: Unit must be transported in the upright position. For proper operation and maximum performance, locate the Merchandising Display Warmer in an area where the ambient air temperature is constant and is a minimum of 70°F (21°C). GRSDM-0903 OPERATION The Merchandising Display Warmer main power is controlled by the ON/OFF toggle switches. The thermostat controlled base can be set to any desired heating level as indicated on the control plate. NOTE: Main power toggle switch must be in the ON position for the heated base to function. NOTE: If the unit is equipped with LED Temperature Controls, see ACCESSORIES for operation. WARNING For safe and proper operation do not place food product directly onto hardcoat surface. [. . . ] Hatco will not accept the return of any Product without prior written approval from Hatco, and all such approved returns shall be made at Buyer's sole expense. HATCO WILL NOT BE LIABLE, UNDER ANY CIRCUMSTANCES, FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, INCLUDING BUT NOT LIMITED TO LABOR COSTS OR LOST PROFITS RESULTING FROM THE USE OF OR INABILITY TO USE THE PRODUCTS OR FROM THE PRODUCTS BEING INCORPORATED IN OR BECOMING A COMPONENT OF ANY OTHER PRODUCT OR GOODS. 15 Form No. GRSDM-0903 HATCO AUTHORIZED PARTS DISTRIBUTORS ALABAMA Jones McLeod Appl. Phoenix 602-252-0402 CALIFORNIA Industrial Electric Huntington Beach 714-379-7100 IOWA Electric Motor Service Co. [. . . ]