User manual HATCO GRMM-0399

[. . . ] Safety instructions that appear in this manual after a warning symbol and the words WARNING or CAUTION printed in bold face are important. Warning means there is the possibility of personal injury to yourself or others. Your Hatco Glo-Ray Mini-Merchandiser is a product of extensive research and field testing. The materials used were selected for maximum durability, attractive appearance and optimum performance. [. . . ] NOTE: If necessary, loosen the "L" brackets on the upper channel and position flush with the side panel before installing top hardware. WARNING Do not lay unit on the side with the control panel or damage to unit could occur. Place a rubber foot onto each leg and install one leg into each corner hole on base. Turn unit upright and position warmer in desired location. Figure 4. Installing Legs Sign Holder Screw GLO-RAY HATCO FOOD WARMER HATCO ATION, CORPOR e, WI Milwauke Cap Nut "L" Bracket Cap Nut 1-1/2" Screw 3/8" Screw Figure 5. GRMM-0399 INSTALLATION LOCATION CAUTION For safe and proper operation, the unit must be located a reasonable distance from combustible walls and materials. If safe distances are not maintained, discoloration or combustion could occur. WARNING Locate the unit at the proper counter height, in an area that is convenient for use. The location should be level to prevent the unit or its contents from accidentally falling, and strong enough to support the weight of the unit and food displayed. OPERATION ALL MODELS WARNING Some exterior surfaces on the unit will get hot. Plug unit into a grounded electrical outlet of the correct voltage, size and plug configuration. See Specifications for details. ON MED Top Controls ­ GRDW-2 HATCO GLO-RAY FOOD WARMER OFF LO W HIG H HATCO CORPORATION, Milwaukee, WI GRDW-2 1. The infrared heat and incandescent lights are controlled by the toggle switch. NOTE: If the unit is equipped with an optional infinite switch, this switch will control the top heat and the toggle switch will control the lights only. On/Off Toggle Switch Infinite Switch (optional) Bottom Controls ­ GRDW-2 80 F 28 C 200 F 93 C 2. Allow unit 15-20 minutes to reach operating temperature. Thermostat Control GRKW-1 1. To set temperature, turn the red Mode Switch counterclockwise to the SP-1 position indicated on the controller. Adjust the Setpoint Screw to the desired temperature and turn the red Mode Switch to the the TEMP position. The surface temperature range is room temperature to 200°F (93°C). Allow 15-20 minutes for unit to reach operating temperature. Figure 6. Operating Controls - GRDW-2 SP1 TEMP °F ON SP1 OFF Thermostat Control On/Off Toggle Switch Figure 7. GRMM-0399 4 MAINTENANCE CLEANING Hatco Glo-Ray Mini-Merchandisers are designed for maximum durability and performance, with minimum maintenance. WARNING To avoid any injury, turn the power switch off, unplug the unit from the power source and allow to cool before performing any maintenance. To preserve the finish of the Glo-Ray Mini-Merchandiser, it is recommended that the surfaces be wiped daily with a damp cloth. [. . . ] Columbia 803-791-4420 TENNESSEE Camp Electric Memphis 901-527-7543 973-575-9145 973-691-6300 NEW YORK Acme American Repairs, Inc. Brooklyn 718-386-2515 Appliance Installation Buffalo 716-884-7425 Northern Parts Dist. Syracuse 315-422-9271 NORTH CAROLINA Authorized Appliance Charlotte 704-377-4501 OHIO Akron/Canton Comm. Akron 330-753-6635 Certified Service Center Cincinnati 513-772-6600 ARR/CRS, Inc. [. . . ]