User manual HATCO GRHWSGDM-0902

[. . . ] GLO-RAY ® Merchandising Warmer GRHW-1SGD Series Installation & Operating Manual I&W # 07. 05. 127. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you are unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] GRHWSGDM-0902 2 SPECIFICATIONS ELECTRICAL RATING CHART Model GRHW-1SGD Voltage 120 Watts 1740 Amps 14. 5 Plug Configuration NEMA 5-15P Shipping Weight 86 lbs. (39 kg) DIMENSIONS Model GRHW-1SGD Width (A) 22-7/8" (58 cm) Depth (B) 20-1/2" (52 cm) Height (C) 24-1/8" (61 cm) B A C 3 Form No. GRHWSGDM-0902 INSTALLATION Sign Holder Screw Personnel Protector Thumb Screws Figure 3. Sign Holder Installation Glo-Ray Merchandising Warmers are shipped with most components pre-assembled. Care should be taken when unpacking shipping carton to avoid damage to unit and components enclosed. To prevent delay in obtaining warranty coverage, fill out and mail in the warranty card. Tighten thumb screws holding personnel protectors in place until snug. Slide each glass panel up into the upper channel then down into the lower channel. NOTE: Side glass panels have a special "Low E" coating applied to one side. The "Low E" coated side must face inward and the word on the glass "out" must face outward. CAUTION Do not lay unit on the side with the control panel or damage to unit could occur. Carefully lift the unit to prevent the rubber feet from tearing off. OU T Figure 4. For safe and proper operation locate the unit indoors where the ambient air temperature is constant and is a minimum of 70°F (21°C). LOCATION For proper operation and maximum performance, locate the Merchandising Warmer in an area where the ambient air temperature is constant and is a minimum of 70°F (21°C). Areas which are susceptible to active air movements or currents should be avoided, i. e. , near exhaust fans or hoods and air conditioning ducts. WARNING For safe and proper operation, the unit must be located a reasonable distance from combustible walls and materials. If safe distances are not maintained, discoloration or combustion could occur. Form No. GRHWSGDM-0902 4 OPERATION CAUTION Locate the unit at the proper counter height, in an area that is convenient for use. The location should be level to prevent the unit or its contents from accidentally falling, and strong enough to support the weight of the unit and food displayed. Plug unit into a properly grounded electrical outlet of the correct voltage, size and plug configuration. The incandescent lights and upper infrared heat are controlled by the rocker switch. The stainless steel base heat is regulated by a preset electronic temperature controller set for 200° F. If an adjustment is required remove the protective cover and follow these steps: A. [. . . ] Hatco reserves the right to accept or reject any such claim in whole or in part. Hatco will not accept the return of any Product without prior written approval from Hatco, and all such approved returns shall be made at Buyer's sole expense. HATCO WILL NOT BE LIABLE, UNDER ANY CIRCUMSTANCES, FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, INCLUDING BUT NOT LIMITED TO LABOR COSTS OR LOST PROFITS RESULTING FROM THE USE OF OR INABILITY TO USE THE PRODUCTS OR FROM THE PRODUCTS BEING INCORPORATED IN OR BECOMING A COMPONENT OF ANY OTHER PRODUCT OR GOODS. 9 Form No. GRHWSGDM-0902 HATCO AUTHORIZED PARTS DISTRIBUTORS ALABAMA Jones McLeod Appl. [. . . ]