User manual HATCO GRBWM-0302

[. . . ] GLO-RAY ® Buffet Warmers GRBW Series Installation & Operating Manual I & W #07. 05. 012. 00 This manual contains important safety information concerning the maintenance, use and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury. If you're unable to understand the contents of this manual, please bring it to the attention of your supervisor. Do not operate this equipment unless you have read and understood the contents of this manual. Este manual contiene importante información sobre seguridad concerniente al mantenimiento, uso y operación de este producto. [. . . ] Specially designed housings and mounting hardware make installation simple. NOTE: Remove protective paper from acrylic surfaces before mounting breath protector. Place weld screws into approximate position to align with holes in breath protector. Carefully position breath protector and "L" channel so holes align with weld screws, then install so weld screws protrude through holes. Secure "L" channel and breath protector to weld screws using cap nuts provided. Figure 4. Installing Breath Protector. LOCATION WARNING For safe and proper operation, the unit must be located a reasonable distance from combustible walls and materials. If safe distances are not maintained, discoloration or combustion could occur. CAUTION Locate the unit at the proper counter height, in an area that is convenient for use. The location should be level to prevent the unit or its contents from accidentally falling, and strong enough to support the weight of the unit and food displayed. 5 Form No. GRBWM-0302 OPERATION CAUTION Some exterior surfaces on the unit will get hot. Plug unit into a properly grounded electrical outlet of the correct voltage, size and plug configuration. The infrared heat and incandescent lights are controlled by the toggle switch. If the unit is equipped with an optional infinite switch, this switch will control the top heat and the toggle switch will control the lights only. The infinite control allows the operator to manually adjust the upper heat output from low to high. Allow unit 15-20 minutes to reach operating temperature. Thermostat Control Figure 5. Operating Controls. ON Top Controls ­ GRBW HATCO GLO-RAY FOOD WARMER MED OFF LO W HIG H HATCO CORPORATION, Milwaukee, WI On/Off Toggle Switch Infinite Switch (optional) Bottom Controls ­ GRBW 80 F 28 C 200 F 93 C Form No. GRBWM-0302 6 MAINTENANCE CLEANING Hatco Glo-Ray Buffet Warmers are designed for maximum durability and performance, with minimum maintenance. WARNING To avoid any injury, turn the power switch off at the fuse disconnect switch/circuit breaker or unplug the unit from the power source and allow to cool completely before performing any maintenance or cleaning. WARNING To avoid electric shock or personal injury, do not steam clean or use excessive water on the unit. WARNING To prevent electric shock, always unplug the unit before performing cleaning or maintenance. To preserve the finish of the Glo-Ray Buffet Warmer, it is recommended that the surfaces be wiped daily with a damp cloth. Hard to reach areas should be cleaned with a small brush and mild soap. [. . . ] HATCO WILL NOT BE LIABLE, UNDER ANY CIRCUMSTANCES, FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES, INCLUDING BUT NOT LIMITED TO LABOR COSTS OR LOST PROFITS RESULTING FROM THE USE OF OR INABILITY TO USE THE PRODUCTS OR FROM THE PRODUCTS BEING INCORPORATED IN OR BECOMING A COMPONENT OF ANY OTHER PRODUCT OR GOODS. 9 Form No. GRBWM-0302 HATCO AUTHORIZED PARTS DISTRIBUTORS ALABAMA Jones McLeod Appl. Phoenix 602-252-0402 CALIFORNIA Industrial Electric Huntington Beach 714-379-7100 Chapman Appl. San Francisco 650-635-1900 COLORADO Hawkins Commercial Appliance Englewood 303-781-5548 DELAWARE Food Equipment Service Wilmington 302-996-9363 FLORIDA Whaley Foodservice Repair Jacksonville 904-725-7800 Nass Service Co. , Inc. [. . . ]